Toshiba 40G300U manual Programmingchannelsinto TVschannel memory, Programmingchannelsautomatically

Programmingchannelsinto the

TV'schannel memory

When you press (_ or _c,_,jon the remote control

or TV control panel, your TV will stop only on the channels you programmed into the TV's channel

memory.

Follow the steps below to program channels into the TV's channel memory.

Programmingchannelsautomatically

Your TV can automatically detect all active channels in your area and store them in its memory. After the channels are programmed automatically, you can manually add or erase individual channels in the channel memory.

Note:

°You must configure the ANT/CABLE input source before programming channels (_

page 30).

,,The automatic channel programming process will erase channels that were previously

programmed into the TV's memory,

°To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control.

°Programming channels when the ANTi

CABLE input is configured for Cable will take substantially longer than when the antenna input is configured for Antenna. This is

normal; however, once channel programming is finished, you should not have to repeat the programming process again unless your Cable TV service lineup changes significantly,

To program chaimels automatically:

1 Configure the antenna input source, if you have not already done so (_1_page> 30).

MENU

2 Press O and open the Setup menu.

Highlight Installationand press @.

(A new set of Installation menu icons will appear, as shown below.) Open the Terrestrialmenu, highlightChannelProgramto bring up the Start

Scan, and press @ again to begin channel programming.

The TV will automatically cycle through all the antenna channels, and store all active channels in the channel memory. While the TV is cycling through the channels, the message "Scanning channels, please wait" appears (as shown above).

EXIT

To cancel channel programming, press O on the remote control (or highlight Cancel in the on- screen display and press @).

When channel programming is finished, press or _ to view the programmed channels.

Setting channel skip

To prevent certain channels from being viewed,

channel positions can be skipped.

1From the Setup menu, highlight Installation and press @.

Press A or Y to select Channel 0ptinns and press

@. The list of channels will appear.

_0_46 55G300U EN-ASindb 81 2010/3/16 74@ 05:48:44