Connecting aft HDNI®or DVIdevice to the HDN] input
The HDM[ input on your TV receives digital audio
and uncompressed digital video froman HDM[
source device, ormacompressed digital video from a
DVI (Digital Visual Interface) source device.
This input is designed to accept HDCP (High-
Bandwidth Digital-Content Protection) wogram
material in digital form from ElA/CEA-861-D-
compliant m consumer electronic devices (such as
a set-top box or DVD player with HDM[ or DVI
output).
The HDM[ input can accept and display VGA,
SVGA, XGA, WXGA, SXGA, 480i (60Hz),480p
(60Hz), 720p (60Hz), 1080i (60Hz)and 1080p
(24Hz/60Hz) signal formats. For detailed signal
specifications, see page 66.
Supported Audio format: Linear PCM, sampling rate
32/44.1/48 kHz
Note: To connect a PCto the HDMI input, seepage 19.
To connect an HDMI device, you will need:
. one HDM[ cable (type Aconnector) per HDM[ device
-Forproper operation, itis recommended that
you usean HDMIcable with the HDMI Logo (
H_mr ).
_Todisplay an 1080i/60Hz signal format, you
willneed a Category 2 cable. Conventional
HDMI/DVI cable may not work properly.
_HDMI cable transfers both video andaudio.
Separate analog audio cables are not
required (see illustration).
-See "Settingthe HDMI®audio mode"
(_,_page33).
_g_,"] wbackpanel
I
'°'i_'i_ Controlpanel
HDIVlldevice _4 _
..... .....
To view the HDM! device video:
Select the HDM[ 1,HDM[ 2,HDM[ 3 orHDM[ 4
video input source on the TV.*
,:, Toselect the video input source, press INPUTon
theremote control (t:+page 22). To programthe
TVremotecontrol tooperate otherdevices, see
Chapter3.
16
To connect a DVI device, you will need:
.one HDMI-to-DV[ adapter cable (HDM[ type A
connector) per DV[ device
-Forproper operation, the length of an HDMI-
to-DVl adapter cable should not exceed 9.8 ft
(3m). The recommended length is 6.6 ft(2m).
.one pair of standard analog audio cables per DVI[
device
-An HDMI-to-DVI adapter cable transfers
video only. Separate analog audio cables
are required (see illustration).
_See "Setting the HDMi°audio mode"
(r:+page 33).
TVback panel
Note: Toensure that the HDM/ or DVI device is reset
properly, it isrecommended that you follow these
procedures:
°When turning on your electronic components,
turn en the TV first, and then the HDMI or
DVI device.
°When turning offyour electronic components,
turn off the HDMI or DVI device first, and
then the TV
[1] EIA/CEA-861-D compliance covers the
transmission of uncompressed digital video
with high-bandwidth digital content protection,
which is being standardized forreception of
high-definition video signals. Because this is
anevolving technology, it is possible thatsome
devices may not operate properly with the TV.
40 46550300U ENASindb 16 2010/,4/16 F@05:48:21