Toshiba 46G30U, 40G30U, 40G300U manual Setting the Hdmj audio mode, Viewing the digital signal meter

4' Highlight Done and press @ to save changes,

and go back to the Channel Labeling window.

Setting the HDMJ® audio mode

To set tile HDMI audio mode:

MENU

1Press O and open the Sound menu.

2Highlight Audio Setupand press @.

3Press A or V to select HDNI 1 Audio and then press 4 or _ to select the HDM[ 1 audio

mode(Auto, Digital,orAnalog)(Autois. the

recommended mode.) See "Connecting an HDM[ or DV[ device to the HDM[ input" (_:_>page 16).

When viewing the HDMI 1 input, if digital audio from the HDM[ input is

Autoavailable, it will be output. [f not, the

TV will automatically detect and output analog audio from the PC Audio input.

When viewing the HDMI 1 input,

Digital digital audio from the HDM[ input will be output.

When viewing the HDM[ 1 input,

Analog analog audio from the PC Audio input will be output.

4' To save your settings, highlight Done and press

O

Note: Because the PC and HDMI- 7 inputs share the same set of analog audio inputs, the PC Audio menu setting influences the HDM! 1 Audio menu setting. If PC Audio is set to "No,"

the HDMI 1 Audio setting changes to "Auto." if PC Audio is set to "Yes," the HDMI 1 Audio setting is set to "Digital" and is grayed out in the menu. (Also see item 4 on page 12 and "Setting the PC Audio" on page 50.)

Viewing the digital signal meter

You can view the digital signal meter in the ANT/ CABLE digital TV input source only.

To view the digital signal meter: Press MENUO and open the Setup menu. Highlight Installationand press @.

3A new set of [nstallation menu icons will appear. Open the Terrestrialmenu, highlight Signal

Meter, and press @.

4' Press AV4_ to select the antenna input and

digital channel whose signal you want to check. Note:

•The physical digital channel number listed in the Signal Meter screen may not correspond

to a virtual TV channel number. Contact your local broadcasters to obtain the RF channel

numbers for your local digital stations.

•The signal strength does not change between virtual channels on the same physical channel.

To close the screen and return to the

Terrestrial menu:

Highlight Done and press @.

To return to normal viewing:

EXIT

Press O.

Setting the time zone

The Time Zone setup will allow you to specify the

correct time zone for your region. This feature will

allow the TV status information to show the correct

time zone information (_ page 58).

To set the time zone:

1From the Setupmenu, highlight Installation and

press @. A new set of Installation menu icons will appear.

Highlight Time Zone, and press @.

3Press 4 or I1_ to select the region, highlight D0ue, and then press @.

(conrin ued)

33

40_46 55G300U EN-ASindb 83 2010/3/16 T@ 05:48:47