Outback Power Systems OBX-IC2024S-120/60 owner manual AC in Hot Key

AC IN Hot Key

The AC IN hot key allows direct control of the AC input from anywhere in the menu system.

AC IN	MAIN--------------------------
	1:35:04p
Hot
	SUM STATUS SETUP ADV
Key

The yellow LED indicator above the AC IN “hot” key has three modes:

•Flashing - an AC source is available, but not connected

•Continuously On - the AC source is connected and in use (unit stops inverting during this time)

•Off - no AC source is present

Multiple AC IN keypresses will call up different AC and charging-related menus..

AC INPUT CONTROL
currently:	USE
DROP USE	OK

PRESS ONCE:

•The AC INPUT CONTROL screen is called up, allowing the user to connect or disconnect the Inverter to an AC input source.

<USE> enables the Inverter to connect to an AC input source.

<DROP> disconnects the AC input source but will allow it to be reconnected if the “low battery cut-off set point” occurs or the Inverter is overloaded.

<OK> returns to the point in the menu system before the user entered the AC INPUT CONTROL menu cycle.

GEN START CONTROL
currently:		MAN-OFF
OFF	AUTO	ON	OK

PRESS TWICE:

•The GEN START CONTROL screen allows changes to the Automatic Generator Start (AGS) mode, which is used with some models of FX inverter.

NOTE: The AGS mode cannot be used with the OBX-IC2024S-120/60 Inverter.

17