Status Error Screens
choose category: |
| choose category: |
MODES METER BATT | PG2 | PG1 ERROR WARN PG3 |
Pressing the <PG2> soft key brings up more STATUS categories.
Pressing the <ERROR> soft key brings up the first ERROR screen.
Pressing the <DOWN> soft key brings up successive METER screens.
P00 | P00 | P00 | ||||||
low ac output |
| No | stacking |
| No | inverter |
| No |
voltage |
|
| error detected |
| overtemp |
|
| |
DOWN | STATUS | PORT | DOWN | UP | TOP PORT | DOWN UP | TOP | PORT |
P00 | P00 | P00 | |||||
low battery | No | phase loss |
| No | high battery |
| No |
voltage |
| error |
|
| voltage |
|
|
DOWN UP | TOP PORT | DOWN UP | TOP | PORT | DOWN UP | TOP | PORT |
P00 | P00 | ||||||
ac output |
| No | ac output |
|
| end of error menu |
|
shorted |
|
| backfeed |
|
|
|
|
DOWN UP | TOP | PORT | DOWN UP | TOP | PORT | UP | TOP STATUS |
Push <TOP> to | Push <STATUS> to |
return to the first | return to the “choose |
ERROR screen. | category” STATUS / |
| FX/PAGE2 screen. |
ERROR Screens
All screens read status as “No” under normal conditions. If the unit shuts off due to a specified error condition, that screen will change to “Yes”.
•low ac output voltage: load too high; Inverter could not supply enough AC voltage to meet demand
•stacking error detected: communication problem among stacked units
•inverter overtemp: Inverter has reached its maximum allowed operating temperature
•low battery voltage: battery voltage is below the LOW BATTERY
•phase loss error: not active in the
•high battery voltage: battery voltage rose above the safe high battery voltage level for 10 seconds
•ac output shorted: Inverter reached its maximum current and shut down
•ac output backfeed: usually indicates another AC power source was connected to the Inverter’s AC output
These are hard faults. The Inverter must be turned off and then on to reset. ERROR screens can only display errors; they do not offer any means to correct them. Generally the nature of the error suggests how to correct it.
29