Outback Power Systems OBX-IC2024S-120/60 owner manual Status Battery Screens

Status Batt(ery) Screens

STATUS/FX/PAGE 1----------------	Pressing the <BATT> soft key brings up the first BATT screen.
choose category:	Pressing the <DOWN> soft key brings up successive BATT screens.
MODES METER BATT PG2

STATUS/FX/MODE-------------		P00	STATUS/FX/MODE		-------------	P00	STATUS/FX/METER-------------			P00
battery	27.8 vdc		battery			27.8 vdc	absorb			28.8 vdc
actual			temp compensated				setpoint
DOWN	STATUS	PORT	DOWN	UP	TOP	PORT	DOWN	UP	TOP	PORT

STATUS/FX/BATT---------------		P00	STATUS/FX/BATT---------------		P00	STATUS/FX/BATT---------------		P00
absorb		00.0 hrs	float		13.6 vdc	float		24.0 hrs
time remaining			setpoint			time remaining
DOWN	UP	TOP PORT	DOWN	UP	TOP PORT	DOWN	UP	TOP PORT

STATUS/FX/BATT---------------		P00	STATUS/FX/BATT---------------		P00	STATUS/FX/BATT---------------		P00
refloat		12.5 vdc	equalize		14.4 vdc	equalize		00.0 hrs
setpoint			setpoint			time remaining
DOWN	UP	TOP PORT	DOWN	UP	TOP PORT	DOWN	UP	TOP PORT

STATUS/FX/BATT---------------			P00
batt temp.			255
(not in degree C/F)
DOWN	UP	TOP	PORT

STATUS/FX/BATT---------------------	Push <TOP> to return to the
end of battery menu
	first METER screen.

UP TOP STATUS

Push <STATUS> to return

to the “choose category”

STATUS screen.

BATT(ERY) Screens

•battery actual: battery voltage as measured by the Inverter

•battery temp compensated: not active in the OBX-IC2024S-120/60 Inverter (reads the same as the battery actual reading)

•absorb set point: charger set point for absorb recharging cycle

•absorb time remaining: time remaining in absorb recharging cycle

•float set point: battery set point for float recharging cycle

•refloat set point: at this battery voltage, the charger restarts the float recharging cycle

•equalize set point: charger set point for equalize recharging cycle

•equalize time remaining: time remaining in equalize recharging cycle

•batt temp: not active in the OBX-IC2024S-120/60 Inverter

The BATT MODE values cannot be changed in the STATUS screens.

28