Outback Power Systems MX60 Exit NEX -EQV +EQV Battery Equalize, Exit Next -HRS +HRS

BATTERY EQUALIZE

Volts 15.0

EXIT NEX -EQV +EQV

BATTERY EQUALIZE

Time

01 Hours

EXIT NEXT -HRS +HRS

Manual Mode

BATTERY EQUALIZE

01 Hrs 15.0 Volts

Check water level

BACK AUTO START STOP

Press either the < –EQV> or <+EQV > soft key to change the EQ voltage, following your battery man- ufacturer’s recommendations. Note that the factory default EQ voltage is set low, the same as the factory default Absorb voltage. Press the <NEXT> soft key to view the BATTERY EQUALIZE Time screen.

Press either the <-HRS> or <+HRS> soft key to set the desired equalization time, up to a seven hour maximum, always following your battery manufac- turer’s recommendations. Press the <NEXT> soft key to view the battery equalization start screen

•Press the <START> soft key to manually begin an equalization cycle. To stop the cycle, press the <STOP> soft key.

•EQ-MPPTdisplay indicates the MX60 is trying to reach the target equalize set point.

•Equalize time “EQ 0:00” in Hours:Minutes displays after the equalize set point is reached.

•The incomplete equalization cycle continues into the next day unless the MX60 is powered off or manually stopped. The remaining EQ time can be viewed in the Log2 Menu.

•EQ cycle terminates when EQ time period is reached.

•After equalizing, an EQ DONE message displayed and a Float cycle begins.

Press the <AUTO> soft key to view the auto equaliza- tion screen.

OutBack Power Systems Inc. 35