STORAGE
Before you store the air compressor, make sure you do the following:
1.Review the "Maintenance" section on the preceding pages and perform scheduled maintenance as necessary.
2.Set the On/Auto/Off lever to "OFF" and unplug unit.
3. |
|
|
|
| Risk of Flying Objects. Pull the regulator knob out and |
|
|
|
| ||
|
|
|
| ||
|
|
|
|
| turn |
|
|
|
|
| |
|
|
|
|
| |
| zero when removing hose or accessories to prevent hose backlash. | ||||
4.Remove the air tool or accessory.
5.Pull ring on safety valve allowing air to bleed from the tank until tank pressure is approximately 20 psi. Release safety valve ring.
6.Drain water from air tank by opening drain valve on bottom of tank.
Risk of Bursting. Water will condense in the air tank. If not drained, water will corrode and weaken the air tank
causing a risk of air tank rupture.
7.After the water has been drained, close the drain or drain valve.
NOTE: If drain valve is plugged, release all air pressure. The valve can then be removed, cleaned, then reinstalled.
8.Wrap electrical cord onto the cord wrap as shown.
9.Protect the air hose from damage (such as being stepped on or run over).
10.Push pulling handle into place for storage.
11.Store the air compressor in a clean and dry location.
IMPORTANT: Only use pulling handle to pull unit, use the carrying handle to lift and carry unit.
21- ENG | D28301 |