8.Install each of the rubber feet on the legs with two
Second Washer
and Hex Nut
Figure 8. Rubber feet.
9.Slide the ends of the handle through the holes in the legs. Do this on the same end as the rubber feet (see Figure 9).
Figure 9. Handle installation.
10.With a pair of pliers, insert a cotter pin through each hole at the end of the handle and bend back one end of the cotter pin to secure the handle to the leg.
Mounting |
|
Components and Hardware Needed: | Qty |
Bandsaw | 1 |
Hex Bolts | 8 |
Flat Washers 5⁄16" | 16 |
Hex Nuts | 8 |
To mount the bandsaw to the stand:
1.With the help of an assistant, set the bandsaw onto the stand (see Figure 10).
Figure 10. Setting the bandsaw.
2.Remove the safety bracket with a Phillips head screwdriver, then tighten down the switch safety bracket (see Figure 11).
Safety Bracket |
Switch Safety Bracket |
Figure 11. Safety bracket installed for shipping.
G1010 4" x 6" |