Grizzly G1010 Test Run Recommended, Adjustments, Factory adjustments that should be verified

Test Run	Recommended
	Adjustments

Projectiles thrown from the machine could cause serious eye injury. Wear safety glasses during assembly and operation.

Starting the machine:

1.Read the entire instruction manual.

2.Make sure all tools and foreign objects have been removed from the machine.

3.Put on safety glasses and secure loose clothing or long hair.

4.Raise the bandsaw by the handle.

5.Start the bandsaw while keeping your finger near the ON/OFF switch at all times dur- ing the test run (Figure 26). The bandsaw should run smoothly with little or no vibra- tion.

—If you suspect any problems, immediately stop the bandsaw and correct before con- tinuing.

—If you need any help with your bandsaw call our Tech Support at (570) 546-9663.

Figure 26. ON/OFF switch.

G1010 4" x 6" Metal-Cutting Bandsaw

The adjustments listed below have been per- formed at the factory. However, because of the many variables involved with shipping, we recommend that you at least verify the following adjustments to ensure the adjustments remain unchanged.

Step-by-step instructions on verifying these adjust- ments can be found in SECTION 7: SERVICE

ADJUSTMENTS.

Factory adjustments that should be verified:

1.Blade Tracking (Page 32).

2.Squaring the Blade (Page 33).

3.Blade Guide Bearings (Page 34).

-23-