Grizzly G1010 instruction manual Pulley Cover, To install the pulley cover

Page 20

3.Attach the bandsaw to the stand with 8 hex bolts, 16 flat washers and 8 hex nuts and tighten with a 12mm wrench (see Figure 12).

Figure 12. Front view of bolt locations.

-18-

Pulley Cover

 

Components and Hardware Needed:

Qty

Pulley Cover

1

Pan Head Screw 14"-20 x 58"

2

To install the pulley cover:

 

1.Slide the pulley cover over the drive-shaft.

2.Align the holes and secure with the two 14"- 20 x 58" screws (see Figure 13).

Figure 13. Installing pulley cover.

G1010 4" x 6" Metal-Cutting Bandsaw

Image 20
Contents Model G1010 Page Table of Contents Warranty and Returns MaintenanceService Contact Info IntroductionForeword Machine Data Sheet Other Identification Safety Safety Instructions for MachineryAlways Lock Mobile Bases if Used Before Operating Machinery Safety Instructions for Metal-Cutting Bandsaws 110/220V Operation Wiring forCircuit Requirements Grounding Extension CordsSET UP Set Up SafetyItems Needed for Set Up UnpackingItems not shown Box Contents Figure QtyInventory Hardware Recognition Chart Clean Up Site ConsiderationsTo assemble the stand Stand AssemblyComponents and Hardware Needed Qty Mounting To mount the bandsaw to the standTo install the pulley cover Pulley CoverUnplug the Bandsaw To install the V-beltBelt To install the handwheel To install the work stopVise Handwheel Work StopVertical Assembly Squaring table to bladeAdjusting table level Test Run Recommended AdjustmentsFactory adjustments that should be verified To change blade speeds Operation Safety Blade SpeedOperations Feed Rate To adjust the feed rateBlade Selection To adjust the angle on the vise To adjust the blade guidesVise Blade GuidesTips for vertical cutting Operation TipsTips for horizontal cutting Accessories H5408-Blade Tensioning GaugeH1300 H1298 G7984 H2347 H0736 H1302-Standard EarmuffsH1302 H4979 H4977 Maintenance CleaningSchedule LubricationBlade Change To change the blade on the bandsawTo adjust the blade tracking on the bandsaw Blade TrackingTo square the blade to the bed of the table Blade Tension Squaring the BladeTo tension the blade on the bandsaw To adjust the blade guide bearings Blade Guide BearingsMaintenance Log Date Approximate Hours Of Use Maintenance PerformedService TroubleshootingSymptom Possible Cause Corrective Action Wiring Diagram G1010 G1010 Wiring diagram Plug Wire Switch WireParts Parts List G1010 DescriptionParts Breakdown G1010 Motor Mount Plate Warranty and Returns Warranty Card CommentsGrizzly INDUSTRIAL, INC BOX BELLINGHAM, WACall Today For a Free Full Color Catalog