Grizzly G1010 instruction manual Blade Tracking, To adjust the blade tracking on the bandsaw

Page 34

Blade Tracking

The blade tracking has been properly set at the factory. The tracking will rarely need to be adjusted if the bandsaw is used properly.

To adjust the blade tracking on the bandsaw:

1.UNPLUG THE BANDSAW!

2.Position the bandsaw in the vertical posi- tion.

3.Open the wheel access cover.

4.Loosen, but do not remove the lower hex bolt in the blade wheel tilting mechanism (Figure 49).

Lower Hex Bolt

Figure 49. Blade tracking adjustments.

5.Relax the blade tension.

6.Adjust the set screw with a 4mm hex wrench shown in Figure 50, then tighten the hex bolt loosened in Step 4.

—Tightening the set screw will move the blade closer to the shoulder of the wheel.

—Loosening the set screw will move the blade away from the shoulder.

Tracking Set Screw

Figure 50. Adjusting tracking set screw.

7.Tension the blade.

8.Reconnect the power and turn ON the bandsaw.

—If the blade tracks along the shoulder of the wheel (without rubbing), the blade is tracking properly and this adjustment is completed.

—If the blade walks away from the shoulder of the wheel or hits the shoulder, repeat Steps 4-7.

9.Replace the blade guard and wheel access cover.

-32-

G1010 4" x 6" Metal-Cutting Bandsaw

Image 34
Contents Model G1010 Page Table of Contents Service MaintenanceWarranty and Returns Foreword IntroductionContact Info Machine Data Sheet Other Identification Safety Safety Instructions for MachineryAlways Lock Mobile Bases if Used Before Operating Machinery Safety Instructions for Metal-Cutting Bandsaws Circuit Requirements Wiring for110/220V Operation Grounding Extension CordsItems Needed for Set Up SET UPSet Up Safety UnpackingInventory Box Contents Figure QtyItems not shown Hardware Recognition Chart Clean Up Site ConsiderationsComponents and Hardware Needed Qty Stand AssemblyTo assemble the stand Mounting To mount the bandsaw to the standTo install the pulley cover Pulley CoverBelt To install the V-beltUnplug the Bandsaw Vise Handwheel To install the handwheelTo install the work stop Work StopVertical Assembly Squaring table to bladeAdjusting table level Factory adjustments that should be verified AdjustmentsTest Run Recommended Operations Operation Safety Blade SpeedTo change blade speeds Blade Selection To adjust the feed rateFeed Rate Vise To adjust the angle on the viseTo adjust the blade guides Blade GuidesTips for horizontal cutting Operation TipsTips for vertical cutting Accessories H5408-Blade Tensioning GaugeH1302 H4979 H4977 H1302-Standard EarmuffsH1300 H1298 G7984 H2347 H0736 Schedule MaintenanceCleaning LubricationBlade Change To change the blade on the bandsawTo adjust the blade tracking on the bandsaw Blade TrackingTo tension the blade on the bandsaw Blade Tension Squaring the BladeTo square the blade to the bed of the table To adjust the blade guide bearings Blade Guide BearingsMaintenance Log Date Approximate Hours Of Use Maintenance PerformedService TroubleshootingSymptom Possible Cause Corrective Action Wiring Diagram G1010 G1010 Wiring diagram Plug Wire Switch WireParts Parts List G1010 DescriptionParts Breakdown G1010 Motor Mount Plate Warranty and Returns Warranty Card CommentsGrizzly INDUSTRIAL, INC BOX BELLINGHAM, WACall Today For a Free Full Color Catalog