Grizzly Comprehensive Guide to Vertical Assembly for Your Bandsaw

Vertical Assembly

The Model G1010 can easily be set up for vertical cutting operations.

Components and Hardware Needed:	Qty
Table	1
Bracket	1
Flat Head Screw 1⁄4"-20 x 1⁄2"	1
Former Switch Safety Bracket	1
Hex Nut 1⁄4"-20	1

To assemble the bandsaw for vertical cutting:

1.Remove the blade guide cover as shown in

Figure 20.

Figure 20. Removing blade guide cover.

2.Install the table and replace the two screws removed in Step 1.

3.Install the bracket shown in Figure 21 with the bolt already in the casting and the flat head screw, and the hex nut.

G1010 4" x 6" Metal-Cutting Bandsaw

Bolt Already

in Casting

Figure 21. Table and bracket installed.

4.Set a square to the side of the blade, as shown in Figure 22, and adjust the bracket to square the table to the blade.

Figure 22. Squaring table to blade.

-21-