Grizzly G1010 instruction manual Maintenance, Schedule, Cleaning, Lubrication

Page 32

SECTION 6: MAINTENANCE

Always disconnect power to the machine before performing maintenance. Failure to do this may result in serious person- al injury.

Schedule

For optimum performance from your machine, follow this maintenance schedule and refer to any specific instructions given in this section.

Daily Check:

•Loose mounting bolts.

•Damaged saw blade.

•Worn or damaged wires.

•Any other unsafe condition.

•Clean after each use.

Monthly Check:

•V-belt tension, damage, or wear.

•Lubricate vise screw.

Annual Check:

•Lubricate gear box.

Cleaning

Cleaning the Model G1010 is relatively easy. After using your bandsaw, remove excess chips by sweeping.

-30-

Lubrication

Before applying lubricant to any area, wipe the area clean to avoid contamination. Lubricate the vice screw shown in Figure 44 with general pur- pose grease.

Figure 44. Vise screw lubrication.

Remove the cover on the gear box in Figure 45 and coat the gears with general purpose grease.

Gear Box

Figure 45. Gear box lubrication.

G1010 4" x 6" Metal-Cutting Bandsaw

Image 32

Contents Model G1010 Page Table of Contents Warranty and Returns MaintenanceService Contact Info IntroductionForeword Machine Data Sheet Other Identification Safety Safety Instructions for MachineryAlways Lock Mobile Bases if Used Before Operating Machinery Safety Instructions for Metal-Cutting Bandsaws 110/220V Operation Wiring forCircuit Requirements Grounding Extension CordsSET UP Set Up SafetyItems Needed for Set Up UnpackingItems not shown Box Contents Figure QtyInventory Hardware Recognition Chart Clean Up Site ConsiderationsTo assemble the stand Stand AssemblyComponents and Hardware Needed Qty Mounting To mount the bandsaw to the standTo install the pulley cover Pulley CoverUnplug the Bandsaw To install the V-beltBelt To install the handwheel To install the work stopVise Handwheel Work StopVertical Assembly Squaring table to bladeAdjusting table level Test Run Recommended AdjustmentsFactory adjustments that should be verified To change blade speeds Operation Safety Blade SpeedOperations Feed Rate To adjust the feed rateBlade Selection To adjust the angle on the vise To adjust the blade guidesVise Blade GuidesTips for vertical cutting Operation TipsTips for horizontal cutting Accessories H5408-Blade Tensioning GaugeH1300 H1298 G7984 H2347 H0736 H1302-Standard EarmuffsH1302 H4979 H4977 Maintenance CleaningSchedule LubricationBlade Change To change the blade on the bandsawTo adjust the blade tracking on the bandsaw Blade TrackingTo square the blade to the bed of the table Blade Tension Squaring the BladeTo tension the blade on the bandsaw To adjust the blade guide bearings Blade Guide BearingsMaintenance Log Date Approximate Hours Of Use Maintenance PerformedService TroubleshootingSymptom Possible Cause Corrective Action Wiring Diagram G1010 G1010 Wiring diagram Plug Wire Switch WireParts Parts List G1010 DescriptionParts Breakdown G1010 Motor Mount Plate Warranty and Returns Warranty Card CommentsGrizzly INDUSTRIAL, INC BOX BELLINGHAM, WACall Today For a Free Full Color Catalog