Grizzly G1010 Vise Handwheel, Work Stop, To install the handwheel, To install the work stop

Vise Handwheel

Components and Hardware Needed:	Qty
Handwheel	1
Handwheel Handle	1
To install the handwheel:

1.Attach the handwheel handle to the handwheel.

2.Slide the handwheel onto the shaft and tighten the set screw with a 4mm hex wrench (see Figure 17).

Figure 17. Installing handwheel.

-20-

Work Stop
Components and Hardware Needed:	Qty
Work Stop	1
Work Stop Shaft	1
To install the work stop:

1.Slide the work stop shaft into the casting until it reaches the stop.

2.Tighten the set screw with the 4mm hex wrench as shown in Figure 18.

Figure 18. Installing work stop shaft.

3.Slide the work stop onto the work stop shaft and tighten the setscrew.

4.Position it down and out of the way for longer stock, as shown in Figure 19, or set the work stop to a measured distance from the blade for consistent, repeatable cut lengths.

Figure 19. Installing work stop.

G1010 4" x 6" Metal-Cutting Bandsaw