Woodstock W1694 instruction manual Assembly, Unpacking, Inventory

Page 12

ASSEMBLY

ASSEMBLY

7	8	10
	9	10

613

14 12

5

11

15

4

1

32

Figure 7. Loose parts shipped with the jointer.

The Model W1694 is a heavy machine at 921⁄2 lbs. Use assistance when lifting or moving the machine.

Unpacking

The Model W1694 was carefully packed when it left our warehouse. If you receive it damaged or missing any parts, please contact Woodstock International Service and Support at 1-360-734- 3482 or send e-mail to:tech-support@shopfox.biz.

Layout and inventory the package contents list- ed to the right and familiarize yourself with the components shown in Figure 7 to ease assembly.

-10-

	Inventory
	Item	Qty
1.	Filter Bag	1
2.	Trash Bag Support Segments	3
3.	Connectors	3
4.	Fence	1
5.	Push Blocks	2
6.	Fence Support	1
7.	90˚ Slide Stop	1
8.	Rubber Feet	4
9.	Fence Tilting Handle	1
10.Filter Bag Spring		1
11.Hardware Bag		1
	• Cap Screws M8-1.25 x 20	6
	• Flat Washers 8mm	6
	• Allen Wrench Set	1
	• Handle Spacers	2
12.Locking Plate Assembly		1
13.Fence Sliding Handle		1
14.Fence Adjusting Bracket		1
15.Dust Port		1

Image 12

Contents Bench TOP Jointer Page Contents Woodstock Service and Support IntroductionAbout Your New Jointer Warranty and Returns SpecificationsSafety Standard Safety Instructions#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Avoiding Potential Injuries Never surface plane without push blocksElectrical Requirements 110V OperationGrounding Extension CordsAssembly UnpackingInventory Initial Cleaning Shop PreparationDust Collection Rubber Feet Fence SupportTo attach the rubber feet, do these steps To attach the fence support, do these stepsFence Assembly To assemble the fence assembly, do these stepsTo install the 90˚ stop slide, do these steps 90˚ Stop SlideDust Port To connect the dust port to a trash bag, do these steps Assembling the trash bag supportAdjustments FenceSetting the fence to 90˚ Fence Angle StopsTo adjust the 45˚ inward angle stop bolt, do these steps To adjust the 45˚ outward angle stop bolt, do these stepsBlade Height To check the cutterhead blade height, do these stepsTo adjust the depth of cut Depth Of CutBlade Guard Blade guard in useOperations Test RunTo test run the Model W1694, do these steps Operation Requirements Correct and incorrect grain Alignment to cutterheadSurface Planing To perform a surface planing operation, do these stepsOperation Requirements sub-section Edge Jointing To perform an edge jointing operation, do these stepsBevel Cutting To perform a bevel cutting operation, do theseMaintenance GeneralTable Surface Sharpening BladesReplacing Blades To replace the cutterhead blades, do these stepsGuard Spring LubricationTo replace a worn out blade guard spring, do these steps Drive Belts Motor BrushesTo replace the drive belts, do these steps Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA

Related manuals

Manual 44 pages 48.28 Kb