Woodstock W1694 instruction manual Adjustments, Fence

Page 18

ADJUSTMENTS

ADJUSTMENTS

UNPLUG the power cord before you do any assem- bly or adjustment tasks! Otherwise, serious per- sonal injury to you or oth- ers may occur!

Fence

The fence assembly has two primary methods of adjustment:

•The face of the fence is adjustable relative to the table surface.

•The fence position is adjustable across the width of the table.

To adjust the fence face angle relative to the table surface, do these steps:

1.Loosen the fence tilting handle (Figure 20).

2.Move the fence face to the desired position.

Precise angle stops will be discussed in the Fence Angle Stops sub-section.

3.Tighten the fence tilting handle.

To adjust the fence position across the width of the table, do these steps:

1.Loosen the fence sliding handle (Figure 20).

2.Move the fence to the desired position across the width of the table. The fence position is adjustable to accommodate workpieces of varying widths and to pro- mote even blade usage and wear.

3.Tighten the fence sliding handle.

Fence Tilting

Handle

Fence Sliding

Handle

Figure 20. Fence bracket assembly.

-16-

Image 18

Contents Bench TOP Jointer Page Contents Woodstock Service and Support IntroductionAbout Your New Jointer Warranty and Returns SpecificationsSafety Standard Safety Instructions#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Avoiding Potential Injuries Never surface plane without push blocksGrounding Electrical Requirements110V Operation Extension CordsAssembly UnpackingInventory Initial Cleaning Shop PreparationDust Collection To attach the rubber feet, do these steps Rubber FeetFence Support To attach the fence support, do these stepsFence Assembly To assemble the fence assembly, do these stepsTo install the 90˚ stop slide, do these steps 90˚ Stop SlideDust Port To connect the dust port to a trash bag, do these steps Assembling the trash bag supportAdjustments FenceSetting the fence to 90˚ Fence Angle StopsTo adjust the 45˚ inward angle stop bolt, do these steps To adjust the 45˚ outward angle stop bolt, do these stepsBlade Height To check the cutterhead blade height, do these stepsTo adjust the depth of cut Depth Of CutBlade Guard Blade guard in useOperations Test RunTo test run the Model W1694, do these steps Operation Requirements Correct and incorrect grain Alignment to cutterheadSurface Planing To perform a surface planing operation, do these stepsOperation Requirements sub-section Edge Jointing To perform an edge jointing operation, do these stepsBevel Cutting To perform a bevel cutting operation, do theseTable Surface MaintenanceGeneral Sharpening BladesReplacing Blades To replace the cutterhead blades, do these stepsGuard Spring LubricationTo replace a worn out blade guard spring, do these steps Drive Belts Motor BrushesTo replace the drive belts, do these steps Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA

Related manuals

Manual 44 pages 48.28 Kb