Woodstock W1694 instruction manual To connect the dust port to a trash bag, do these steps

Page 17

To connect the dust port to a trash bag, do these steps:

1.Slip the filter bag spring into the filter bag arm.

2.Slide the filter bag arm over the dust port.

3. Assemble the trash bag support by sliding the connectors into the channels of the trash bag support segments (Figure 17).

4.Slide the opening of the trash bag inside and over the trash bag support (Figure 18). Let the trash bag hang over approximately 3"- 4".

5.Secure the filter bag to the trash bag/sup- port assembly with the filter bag band (Figure 19). Make sure the filter bag band rests in the channel of the trash bag sup- port.

Figure 17. Assembling the trash bag support.

ASSEMBLY

Figure 18. Sliding the trash bag over the trash

bag support.

Figure 19. Filter bag secured to

the trash bag.

-15-

Image 17

Contents Bench TOP Jointer Page Contents About Your New Jointer Woodstock Service and SupportIntroduction Specifications Warranty and ReturnsStandard Safety Instructions Safety#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Never surface plane without push blocks Avoiding Potential Injuries110V Operation Electrical RequirementsGrounding Extension CordsInventory AssemblyUnpacking Dust Collection Initial CleaningShop Preparation Fence Support Rubber FeetTo attach the rubber feet, do these steps To attach the fence support, do these stepsTo assemble the fence assembly, do these steps Fence AssemblyDust Port To install the 90˚ stop slide, do these steps90˚ Stop Slide Assembling the trash bag support To connect the dust port to a trash bag, do these stepsFence AdjustmentsFence Angle Stops Setting the fence to 90˚To adjust the 45˚ outward angle stop bolt, do these steps To adjust the 45˚ inward angle stop bolt, do these stepsTo check the cutterhead blade height, do these steps Blade HeightDepth Of Cut To adjust the depth of cutBlade guard in use Blade GuardTo test run the Model W1694, do these steps OperationsTest Run Correct and incorrect grain Alignment to cutterhead Operation RequirementsOperation Requirements sub-section Surface PlaningTo perform a surface planing operation, do these steps To perform an edge jointing operation, do these steps Edge JointingTo perform a bevel cutting operation, do these Bevel CuttingGeneral MaintenanceTable Surface Sharpening BladesTo replace the cutterhead blades, do these steps Replacing BladesTo replace a worn out blade guard spring, do these steps Guard SpringLubrication To replace the drive belts, do these steps Drive BeltsMotor Brushes Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA

Related manuals

Manual 44 pages 48.28 Kb