Woodstock W1694 instruction manual To adjust the 45˚ inward angle stop bolt, do these steps

Page 20

ADJUSTMENTS

To adjust the 45˚ inward angle stop bolt, do these steps:

1.Slide the 90˚ stop slide away from the back of the fence.

2.Using a 45˚ square, position the fence 45˚ relative to the table surface.

3.Loosen the jam nut on the 45˚ inward stop bolt (Figure 23).

4.Adjust the 45˚ inward stop bolt until it makes contact with the back of the fence.

5.Retighten the jam nut loosened in step 3.

To adjust the 45˚ outward angle stop bolt, do these steps:

1.Using a sliding bevel adjusted to 135˚, posi- tion the fence 135˚ (45˚ outward) relative to the table surface.

2.Loosen the jam nut on the 45˚ outward stop bolt (Figure 24).

3.Adjust the 45˚ outward stop bolt until it makes contact with the fence adjusting bracket.

4.Retighten the jam nut loosened in step 2.

Figure 23. 45˚ inward angle stop bolt.

Figure 24. 45˚ outward angle stop bolt.

-18-

Image 20

Contents Bench TOP Jointer Page Contents About Your New Jointer Woodstock Service and SupportIntroduction Warranty and Returns SpecificationsSafety Standard Safety Instructions#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Avoiding Potential Injuries Never surface plane without push blocksElectrical Requirements 110V OperationGrounding Extension CordsInventory AssemblyUnpacking Dust Collection Initial CleaningShop Preparation Rubber Feet Fence SupportTo attach the rubber feet, do these steps To attach the fence support, do these stepsFence Assembly To assemble the fence assembly, do these stepsDust Port To install the 90˚ stop slide, do these steps90˚ Stop Slide To connect the dust port to a trash bag, do these steps Assembling the trash bag supportAdjustments FenceSetting the fence to 90˚ Fence Angle StopsTo adjust the 45˚ inward angle stop bolt, do these steps To adjust the 45˚ outward angle stop bolt, do these stepsBlade Height To check the cutterhead blade height, do these stepsTo adjust the depth of cut Depth Of CutBlade Guard Blade guard in useTo test run the Model W1694, do these steps OperationsTest Run Operation Requirements Correct and incorrect grain Alignment to cutterheadOperation Requirements sub-section Surface PlaningTo perform a surface planing operation, do these steps Edge Jointing To perform an edge jointing operation, do these stepsBevel Cutting To perform a bevel cutting operation, do theseMaintenance GeneralTable Surface Sharpening BladesReplacing Blades To replace the cutterhead blades, do these stepsTo replace a worn out blade guard spring, do these steps Guard SpringLubrication To replace the drive belts, do these steps Drive BeltsMotor Brushes Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA

Related manuals

Manual 44 pages 48.28 Kb