Woodstock instruction manual Operations, Test Run, To test run the Model W1694, do these steps

Page 24

OPERATIONS

Test Run

Once assembly is complete, the machine is ready for a test run. The purpose of a test run is to identify any unusual noises and vibrations, as well as to confirm that the machine is perform- ing as intended.

To test run the Model W1694, do these steps:

1.Make sure that all tools have been removed from the jointer.

2.Turn the jointer ON.

3.Once the jointer is running, listen for any unusual noises. The machine should run smoothly with little or no vibrations.

•If there are any unusual noises or vibra- tions, stop the jointer immediately by pushing the paddle switch down.

4.Unplug the jointer and investigate the source of the noise or vibration. DO NOT make any adjustments to the jointer while it is plugged in. The jointer should not be run any further until the problems are cor- rected.

OPERATIONS

THIS MACHINE throws wood chips and sawdust. Wear safety glasses or a face shield during all operations.

KEEP loose clothing rolled up and out of the way of machinery and keep hair pulled back.

THIS MACHINE produces sawdust that may cause allergic reactions or res- piratory problems. Wear a dust mask or respirator in addition to using a dust collector.

-22-

Image 24

Contents Bench TOP Jointer Page Contents Woodstock Service and Support IntroductionAbout Your New Jointer Warranty and Returns SpecificationsSafety Standard Safety Instructions#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Avoiding Potential Injuries Never surface plane without push blocksElectrical Requirements 110V OperationGrounding Extension CordsAssembly UnpackingInventory Initial Cleaning Shop PreparationDust Collection Rubber Feet Fence SupportTo attach the rubber feet, do these steps To attach the fence support, do these stepsFence Assembly To assemble the fence assembly, do these stepsTo install the 90˚ stop slide, do these steps 90˚ Stop SlideDust Port To connect the dust port to a trash bag, do these steps Assembling the trash bag supportAdjustments FenceSetting the fence to 90˚ Fence Angle StopsTo adjust the 45˚ inward angle stop bolt, do these steps To adjust the 45˚ outward angle stop bolt, do these stepsBlade Height To check the cutterhead blade height, do these stepsTo adjust the depth of cut Depth Of CutBlade Guard Blade guard in useOperations Test RunTo test run the Model W1694, do these steps Operation Requirements Correct and incorrect grain Alignment to cutterheadSurface Planing To perform a surface planing operation, do these stepsOperation Requirements sub-section Edge Jointing To perform an edge jointing operation, do these stepsBevel Cutting To perform a bevel cutting operation, do theseMaintenance GeneralTable Surface Sharpening BladesReplacing Blades To replace the cutterhead blades, do these stepsGuard Spring LubricationTo replace a worn out blade guard spring, do these steps Drive Belts Motor BrushesTo replace the drive belts, do these steps Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA

Related manuals

Manual 44 pages 48.28 Kb