Woodstock W1694 90˚ Stop Slide, Dust Port, To install the 90˚ stop slide, do these steps

Page 16

ASSEMBLY

90˚ Stop Slide

To install the 90˚ stop slide, do these steps:

Slide the 90˚ stop slide under the limit plate as shown in Figure 14. Do not worry about its exact position at this time. Further adjustment of the 90˚ stop slide will be discussed in the Adjustments section.

Dust Port

The Model W1694 has a 212" dust port with a built-in suction impeller. The dust port can con- nect to a standard 30 gallon trash can or a 30 gallon plastic trash bag.

To connect the dust port to a trash can, do these steps:

1.Slip the filter bag spring into the filter bag arm (Figure 15).

2.Slide the filter bag arm over the dust port.

3. Secure the filter bag over the rim of the trash can with the filter bag band (Figure 16).

-14-

Figure 14. Installing the 90˚ stop slide.

Figure 15. Correctly installed filter bag

spring.

Figure 16. Filter bag secured to

the trash can.

Image 16
Contents Bench TOP Jointer Page Contents Introduction Woodstock Service and SupportAbout Your New Jointer Warranty and Returns SpecificationsSafety Standard Safety Instructions#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Avoiding Potential Injuries Never surface plane without push blocksElectrical Requirements 110V OperationGrounding Extension CordsUnpacking AssemblyInventory Shop Preparation Initial CleaningDust Collection Rubber Feet Fence SupportTo attach the rubber feet, do these steps To attach the fence support, do these stepsFence Assembly To assemble the fence assembly, do these steps90˚ Stop Slide To install the 90˚ stop slide, do these stepsDust Port To connect the dust port to a trash bag, do these steps Assembling the trash bag supportAdjustments FenceSetting the fence to 90˚ Fence Angle StopsTo adjust the 45˚ inward angle stop bolt, do these steps To adjust the 45˚ outward angle stop bolt, do these stepsBlade Height To check the cutterhead blade height, do these stepsTo adjust the depth of cut Depth Of CutBlade Guard Blade guard in useTest Run OperationsTo test run the Model W1694, do these steps Operation Requirements Correct and incorrect grain Alignment to cutterheadTo perform a surface planing operation, do these steps Surface PlaningOperation Requirements sub-section Edge Jointing To perform an edge jointing operation, do these stepsBevel Cutting To perform a bevel cutting operation, do theseMaintenance GeneralTable Surface Sharpening BladesReplacing Blades To replace the cutterhead blades, do these stepsLubrication Guard SpringTo replace a worn out blade guard spring, do these steps Motor Brushes Drive BeltsTo replace the drive belts, do these steps Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA
Related manuals
Manual 44 pages 48.28 Kb