Woodstock W1694 Rubber Feet, Fence Support, To attach the rubber feet, do these steps

Page 14

ASSEMBLY

UNPLUG POWER CORD before you do any assem- bly or adjustment tasks! Otherwise, serious per- sonal injury to you or oth- ers may occur!

READ and understand this entire instruction manual before performing any operations with your machine. Serious personal injury may occur if safety and operational informa- tion is not understood and

followed.

Rubber Feet

To attach the rubber feet, do these steps:

Slide the four rubber feet onto the four corners of the jointer base (Figure 8).

Fence Support

To attach the fence support, do these steps:

1.Align the fence support with the mounting holes on the back of the jointer (Figure 9).

Make sure the slot on the top of the fence support is positioned correctly.

2.Secure the fence support to the jointer with two 8mm flat washers and two M8-1.25 x 20 cap screws.

3.Secure the locking plate assembly to the fence support with the fence sliding handle (Figure 10).

-12-

Rubber Feet

Figure 8. Attached rubber feet.

Figure 9. Aligning the fence support.

Locking Plate

Figure 10. Secured locking plate.

Image 14

Contents Bench TOP Jointer Page Contents About Your New Jointer Woodstock Service and SupportIntroduction Warranty and Returns SpecificationsSafety Standard Safety Instructions#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Avoiding Potential Injuries Never surface plane without push blocksGrounding Electrical Requirements110V Operation Extension CordsInventory AssemblyUnpacking Dust Collection Initial CleaningShop Preparation To attach the rubber feet, do these steps Rubber FeetFence Support To attach the fence support, do these stepsFence Assembly To assemble the fence assembly, do these stepsDust Port To install the 90˚ stop slide, do these steps90˚ Stop Slide To connect the dust port to a trash bag, do these steps Assembling the trash bag supportAdjustments FenceSetting the fence to 90˚ Fence Angle StopsTo adjust the 45˚ inward angle stop bolt, do these steps To adjust the 45˚ outward angle stop bolt, do these stepsBlade Height To check the cutterhead blade height, do these stepsTo adjust the depth of cut Depth Of CutBlade Guard Blade guard in useTo test run the Model W1694, do these steps OperationsTest Run Operation Requirements Correct and incorrect grain Alignment to cutterheadOperation Requirements sub-section Surface PlaningTo perform a surface planing operation, do these steps Edge Jointing To perform an edge jointing operation, do these stepsBevel Cutting To perform a bevel cutting operation, do theseTable Surface MaintenanceGeneral Sharpening BladesReplacing Blades To replace the cutterhead blades, do these stepsTo replace a worn out blade guard spring, do these steps Guard SpringLubrication To replace the drive belts, do these steps Drive BeltsMotor Brushes Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA

Related manuals

Manual 44 pages 48.28 Kb