Banner L-GAGE manual GAGEHigh-Resolution MINI-ARRAYSensor Specifications

PICK-TO-LIGHT SCREENSGAUGING

RADAR TEMPERATURE MEASURING LIGHT ULTRASONIC LIGHT

MEASUREMENT & INSPECTION

A-GAGE®High--ResolutionMINI--ARRAY®ControllerSpecifications (cont’d)
		®
Analog Outputs	Voltage-sourcing outputs: 0 to 10V dc (25 mA current limit)
	Current-sinking outputs: 4 to 20 mA (16 to 30V dc input)
	Resolution: Span / Number of sensing channels
	Linearity: 0.1% of full scale	Temperature variation: 0.01% of full scale per ° C
Output Configuration	MAHCVP-1:Two PNP discrete (switched), two 0-10V voltage sourcing
	MAHCVN-1:Two NPN discrete (switched), two 0-10V voltage sourcing
	MAHCIP-1:Two PNP discrete (switched), two 4-20 mA current sinking
	MAHCIN-1:Two NPN discrete (switched), two 4-20 mA current sinking
System Programming	Via RS-232 interface to PC-compatible computer running Windows® 95, 98, NT, ME, XP or 2000 and
	using software supplied with each control module.
Status Indicators	Output 1(Red): Lights to indicate Discrete Output #1 is active
	Alarm (Red): Lights to indicate Discrete Output #2 is active
	Gate (Red): Lights to indicate Trigger (Gate) is active
	Align (Green): Lights to indicate emitter and receiver are aligned
	Diagnostics indicator: (Key on controller side label) Identifies System errors and status
Construction	Polycarbonate housing; mounts to flat surface or directly onto 35-mm DIN rail
Environmental Rating	NEMA 1; IP20
Operating Conditions	Temperature: 0° to +50° C	Relative humidity: 95% @ 50˚ C (non-condensing)
Certifications
Hookup Diagrams	0-10V sourcing: MI25 (p. 538) 4 to 20 mA voltage: MI26 (p. 538)

A-GAGE®High-Resolution MINI-ARRAY®Sensor Specifications

Emitter/Receiver Range	380 mm to 1.8 m
Minimum Object Sensitivity	2.5 mm
Sensor Scan Time	1.8 to 58.4 milliseconds, depending on scanning method and sensor length plus 1 millisecond post
	processing time for controller.
Power Requirements	12V dc ±2%, supplied by controller
Connections	Sensors connect to controller using two 5-conductor quick-disconnect cables (one each for emitter
	and receiver), ordered separately. Use only Banner cables, which incorporate a “twisted pair”
	for noise immunity. Cables measure 8.1 mm in diameter and are shielded and PVC-jacketed.
	Conductors are 20 gauge (0.9 mm). Emitter and receiver cables may not exceed 75 m long, each.
	See page 421.
Status Indicators	Emitter: Red LED lights to indicate proper emitter operation
	Receiver: Green indicates sensors aligned
	Yellow indicates marginal alignment of one or more beams
	Red indicates sensors misaligned or one or more beam(s) blocked
Construction	Aluminum, with black anodized finish; acrylic lens cover
Environmental Rating	NEMA 4, 13; IP65
Operating Conditions	Temperature: 0° to +50° C	Relative humidity: 95% at 50° C (non-condensing)
Certifications

294 More information online at bannerengineering.com