When running the laser system, | ∙ Incorrect BIOS setting in computer | ∙ Refer to manual on proper setting |
the laser system will “freeze”, the | ∙ Using a printer cable longer than 6 ft. | ∙ Use only a 6 ft., IEEE1284 compliant |
clock will keep advancing, but |
| printer cable |
the operator will have no control | ∙ Bad printer cable | ∙ Replace printer cable |
over the system. The only way to | ∙ Usage of device in between computer | ∙ Connect the laser system directly from |
restore the system is to power | and laser system | computer with the printer cable |
the laser off and then back on. | ∙ Some other parallel port driver | ∙ Remove all other parallel port drivers |
This is a symptom of file | interfering with the laser system printer | and try again |
corruption. | driver | ∙ Replace laser system’s CPU |
| ∙ Damaged port in CPU |
|
Ihr ULS Vertragshändler :
MarkIDent GmbH Winterspürerstr. 19 78333 Stockach www.markident.de