InFocus M-300 manual Cart Assembly

Installation 2-5

Cart Assembly

Since packaging of this unit may vary from time to time, make sure that you locate the following items from within the crate or inside of the front door of the system:

(A)Back Panel

(B)Legs (both are identical)

(C)10-32 x 3/8 socket head screws with lock washers and flat washers (2)

(D)Guide pins (factory installed)

(E)Nuts (4)

(F)Locking Casters with nuts (2 - Front)

(G)Non-locking Casters with nuts (2 - Rear)

(H)1/4 -20 x ½ socket head screws with lock washers and flat washers (8)

TO LASER

SYSTEM BODY

Tab

Tab

TO LASER

SYSTEM BODY

TO LASER

SYSTEM BODY

TO LASER

SYSTEM BODY

TO LASER

SYSTEM BODY

TO LASER

SYSTEM BODY

1.Attach the back panel (A) to the legs (B) with the 4 screws and lockwashers (C).

2.Thread the 4 nuts (E) all the way down onto the caster shafts until they bottom out.

3.Carefully turn the stand upside down.

4.Install the locking casters (F) in the front and the non-locking casters (G) in the rear.

5.Tighten down the casters securely to the legs.

6.Carefully turn the stand right side up.

7.Lock down the front casters so the stand will not roll.

8.Pay close attention to the guide pins (D) and the tabs on the back panel (A) when placing the laser system on the cart assembly.