InFocus M-300 manual Male Female

6-12 Sample Materials

DELRIN (SEAL PRESS)

RASTER ENGRAVING

LASER WATTAGE	POWER	SPEED	PPI	PASS	DEPTH
15	100	18	500	1	.015”
20	100	23	500	1	.015”
25	100	29	500	1	.015”
30	100	35	500	1	.015”
35	100	41	500	1	.015”
40	100	47	500	1	.015”
45	100	53	500	1	.015”
50	100	58	500	1	.015”
VECTOR CUTTING
LASER WATTAGE	POWER	SPEED	PPI	PASS	DEPTH
15	75	1.2	200	1	.060”
20	75	1.6	200	1	.060”
25	75	2.0	200	1	.060”
30	75	2.4	200	1	.060”
35	75	2.8	200	1	.060”
40	75	3.2	200	1	.060”
45	75	3.6	200	1	.060”
50	75	4.0	200	1	.060”

		COMMENTS
		The laser system can be used to make dies
		for seal presses. It can engrave and cut out
		a typical Notary Seal in less than 5 minutes.
		Create the male with a white graphic and a
		black background. Mirror the image and
		invert it by making the background white and
		the graphic black. Add a .010 inch black
		outline to the graphic portion of the female
MALE	FEMALE	side. This will give the greater clearance to
		the female side to prevent the paper from

piercing through when the male side of the seal presses into the female side. Once the seal is made and fastened to the press, make several impressions onto 400 grit sandpaper to smoothen out the edges of the plastic. Make sure you turn the sandpaper over to get both sides of the seal.

LASER CUTTING THIS MATERIAL CAN CAUSE FLAMING. Use caution when attempting to cut this material. Make sure that the flame does not come in contact with any part of the laser system. NEVER leave the machine unattended while processing any material. Damages caused by processing any material WILL NOT be covered under warranty.