Installation 2-7
Laser Cartridge Installation
Before connecting and powering on your system, you must install the Laser Cartridge. Make sure that your power cord IS NOT plugged in at this time.
With your fingers, press on the backside of the two hinges to release the latch.
Gently fold back the rear cover. Visually locate the two Mounting Blocks, the Laser Latch, Alignment Fork, and Power Connector. Notice that the Alignment Fork has two plates, one small and one large. Locate the gap between the two plates.
Observe the “V” groove along the upper and lower part of the Laser Cartridge. Also locate the Alignment Plate at the end of the Laser Cartridge.