InFocus M-300 manual Cork

Sample Materials 6-11

CORK

RASTER ENGRAVING

LASER WATTAGE	POWER	SPEED	PPI	PASS	DEPTH
15	80	30	500	1	.010”
20	80	40	500	1	.010”
25	80	50	500	1	.010”
30	80	60	500	1	.010”
35	80	70	500	1	.010”
40	80	80	500	1	.010”
45	80	90	500	1	.010”
50	80	100	500	1	.010”
VECTOR ENGRAVING
LASER WATTAGE	POWER	SPEED	PPI	PASS	DEPTH
15	20	4.0	500	1	.010”
20	15	4.0	500	1	.010”
25	12	4.0	500	1	.010”
30	10	4.0	500	1	.010”
35	9	4.0	500	1	.010”
40	8	4.0	500	1	.010”
45	7	4.0	500	1	.010”
50	6	4.0	500	1	.010”
VECTOR CUTTING
LASER WATTAGE	POWER	SPEED	PPI	PASS	DEPTH
15	100	1.6	100	1	.060”
20	75	1.6	100	1	.060”
25	60	1.6	100	1	.060”
30	50	1.6	100	1	.060”
35	43	1.6	100	1	.060”
40	38	1.6	100	1	.060”
45	33	1.6	100	1	.060”
50	30	1.6	100	1	.060”

COMMENTS

Cork is not very popular for engraving but it does engrave and cut nicely. Cork is mainly used for making gaskets by vector cutting the gasket patterns.

LASER CUTTING THIS MATERIAL CAN CAUSE FLAMING AND SPARKING. Use caution when attempting to cut this material. It would be better to use a longer focal length lens to prevent the lens from being damaged during processing. NEVER leave the machine unattended while processing any material. Damages caused by processing any material WILL NOT be covered under warranty.