Sears 113.241591 owner manual Important -- Read Before Proceeding, Installing Handwheels

If you mount the saw on any other bench, make sure that there is an opening in the top of the bench the same size as the opening =nthe bottom of the saw so that the sawdust can drop through. Recommended working height is 33to 37 inches from the top of the saw table to the floor.

11,1/4

1

OPENING

16"3/4"

15,1

@

7116" DIA, HOLES--_ --_

FRONT Ot: SAW

IMPORTANT -- Read Before Proceeding

Blade cannot be more than 2 inches above the table

top when tilting the sawblade to make bevel cuts or adjustments, Lower blade to 2 inches or closer to the table top to tilt the saw, Failure to do this may result in damage to your saw.

INSTALLING HANDWHEELS

Line up FLAT SPOTS on shaft and handwheel, push handwheel onto shaft. Install screw and Iockwashe r to lOck handwheels on shaft.

CHECKING TABLE INS ERT

1.Insert should be even with table top. Check as shown. Loosen flat head screw that holds insert and adjust the four set screws as necessary, Tighten flat head screw. Do not _ighten screw to the point where it deflects the insert.

2.To remove insert.

A. Loosen Phillips Flat Head Screw.

B:Lift insert from front end, and pull toward front of saw.

3.To replace insert:

Place insert into insert opening in table and push toward rear of sawto engage spring clip and until

keyslot in insert w ! drop over screw T ghten screw.

Do not tighten screw to the point where it will deflect the insert.

.OCKWASHER

	/
	/
	10-32 x 3/4 IN.
	PHILLIPS
ELEVATION	HEAD SCREW
HANOWB	TILT HANDWHEEL

//

3/32 IN

SETSCREW WRENCH

/