Sears 113.241591 owner manual Adjusting RiP Scale iNDiCATOR, INSTALLING Blade Guard

HEX SCREWS

FENCE HEAD

3, The rip fence must be PARALLEL with the

sawblade and miter Gauge grooves Move fence until it is along side of groove. E)o NOT

LOCK IT. It sPiou/d be parallel to groove, If it rs not;

A. Loosen the two "Hex Head Screws."

B. Hold fence head tightly against bar.. move end of fence so that it is parallel with groove.

C. Alternately tighten the screws,

\

ADJUSTING RiP SCALE iNDiCATOR

1.Turn ELEVATION HANDWHEEL clockwise until blade is up as high as it will go.

IMPORTANT: BLADE must be SQUARE (90 °) to

TABLE, in order to ALIGN rip fence,

2.Using a rule, position fence on right side of sawblade 2 in. from the sides of the teeth...

tighten lock handle,

3.Loosen screw holding the indicator.., adjust so that it points to "2" on the rip scale.., tighten screw.

NOTE: If you cannot adjust indicator so that it poin ts to "2", loosen the screws holding the front guide bar and move the guide bar.

iNSTALLING BLADE GUARD

1.From Among the loose parts find:

4 Truss Head Screws 1/4-20 x 3/4 in. long 2 Hex Socket Setscrews 1/4-20 x 1 in. long 4 Washers 17/64 x 5/8 x 1/32

6 Lockwashers 1/4 in. External Type (approx, die. of hole 1/4 in.)

2 Hex Head Nuts 1/4-20 {approx. die. of hole 1/4 in.)

2 Wing Nuts 1/4-20

(aprox, dia. of hole 1/4 in.)

1 Spreader Support

1 Plate Nut

1 Spreader Clamp

1 Spreader Bracket

\

\

	SPREADER	SUPPORT
	PLATE
	NUT
		SPREAOER	CLAMP
				NUT
FLAT WASHER		EXT. 1/4 IN.
17_41N
		FLAT	WASHER
			IN.	HOLE
EXT. IN	IN.
HEX	NUT	EXT,	!/4	tN.
	/
FLAT WASHER		NUT
17/64 IN.HOLE
		,OCKET	HEAD SETSCREW
	EXT. 1/4 IN.	HEX NUT	1 If_. LONG

23