Sears 113.241591 owner manual Installing RiP Fence Guide Bars, Mounting Switch

4.Lineup front andtopof theextensionwith the front and top of the table. Usea combination square to line-up these edges. SLIGHTLY TIGHTENnutswith awrench.

CHECK WITH SQUARE

AT 2 PLACES

MARKED WITH "X"

ii

5.tf adjustment _s necessary you should tap the

extension into position using a hammer and a block of wood. Then firmly tighten nuts.

MOUNTING SWITCH

1• From among loose parts find the following: 2 Hex Head Screws 5/16-18 x 3/4 in. long 2 Flatwashers (alia. of hole 21/64 in.)

2 External Lockwashers

2 Hex Nuts 5/!6-18

2.Insert two 3/4 inch screws through two flat washers then through holes in switch.

3.Insert screws through holes eight and ten in front fence guide bar as illustrated•

4.Install two Iockwashers and nuts. Tighten nuts.

INSTALLING RiP FENCE GUIDE BARS

1.From among the loose parts find the following hardware:

2Hex Plead Screws, 5/16-18 x 1-3/4 in. long

2Hex Head Screws, 5/16-18 x 1 in. long

4External Lockwashers, 5/16 in. (approx. dia. of hole 5/16 in.)

4Hex Nuts, 5/16-18 (approx. dia. of hole 5/16 in.)

2SpaceFs, 3/4 in. dia. x !/2 in. long

2Self-threading nuts

1Fence Guide Bar Rod

2.Lay guide bars on saw table,

NOTE: The various holes in the bar allows them to be positioned on this saw and also makes them adaptable to other models.

3.Insert a 1-3/4 inch long screw through the

THIRD hole IN THE FRONT BAR as illustrated

•..Insert another 1-3/4 inch long screwthrough the SEVENTH hole in bar.

4.Place spacers on screws.

BLOCK OF WOOD :

\

\

JAM NUT 5/t6-18

"_ 8 /LOCKWASHER

@-_ ,8TH HOLE

w_

	%'_-'-- WASH ER
		t
	HEX HEAD		SCREW
	5/16-18		x 3/4	IN.
	LEFT	SiDE		OF
	FRONT		GUIDE		BAR
7TH HOLE	(GUIDE	BAR			IS TO	BE
	TURNED		END		FOR	END

3RD HOLE AFTER SCREWS ARE

INSTALLED)

SCREW 5/16-18 x 1-3./4 IN.

19