Baum Bros. Imports 26.4 Changing of cutting stick, Removing of cutting stick, Normal Turn over

6.0 Knife Change

Changing of cutting stick

The BAUM sinus cutting stick is made of high resistance plastic material. Due to the unusual wavy design a tight fitting in the table grove is assured without the need for glue or screw.

Each cutting stick is useable 4 times as they are turned around.

Removing of cutting stick

Tool needed: normal screw driver

1.Lift cutting stick slightly on the left side cutting stick stop

2.Prey out cutting stick carefully from left toward the right. Clean cutting stick table grove!

Inserting of cutting stick

1.Rest cutting stick end against the right stop and work into the grove

2.Follow the wavy form of the cutting stick when pressing into the table grove. Press down hard to assure total seating of stick.

normal turn over replace

K6 - 5