BM 2610945718
Operating Instructions
DEPTH ADJUSTMENT
Disconnect battery pack from tool. Loosen the depth adjustment lever located on the right side of the tool. Hold the foot down with one hand and raise or lower saw by the handle.
Tighten lever at the depth setting desired. Check desired depth (Fig. 3).
Not more than one tooth length of the blade should extend below the material to be cut, for minimum splintering (Fig. 4).
FIG. 3 | FIG. 4 |
CALIBRATED 
2x
DEPTH
BRACKET
DEPTH
ADJUSTMENT LEVER
ONE TOOTH LENGTH SHOULD
PENETRATE WOOD FOR MINIMUM SPLINTERING
SAFETY SWITCH
The safety switch is designed to prevent accidental starts. To operate safety switch, press the release button with your thumb on either side of handle to disengage the lock, then pull the trigger (Fig. 5). When the trigger is released the button will engage the safety switch automatically, and the trigger will no longer operate. (See Switch & General Cuts on page 12.)
FIG. 5
SAFETY SWITCH
RELEASE BUTTON
90° CUTTING ANGLE CHECK
Disconnect battery pack from tool. Set foot to maximum depth of cut setting. Loosen bevel adjustment lever, set to 0° on quadrant, retighten lever and check for 90° angle between the blade and bottom plane of foot with a square (Fig. 6). Make adjustments by turning the small alignment screw from bottom side of foot, if necessary (Fig. 7).
FIG. 6 | BEVEL | FIG. 7 |
|
| |
| ADJUSTMENT |
|
| KNOB |
|