Craftsman 509398, 509399 owner manual Installing Front Table

Page 15

Assembly

Installing Front Table

1.Set out:

-front table

-tee nut

-1/4 " U-clip

-1/4" diam. x 7/8" long cup point set screw

-four 1/4" diam. x 1" long pan head screws

-1/4" dia. x 1-3/4" long pan head screw

-five 17/64" I.D. x 5/8" O.D. flat washers

-four 1/4" lockwashers

-four 1/4" diam. hex nuts

2.Identify top and bottom of table: top has counterbored holes. Place table bottom side up on solid surface. Hammer tee nut into lev- eling hole. (This hole is not counterbored from the top).

3.Slide a U-Cliponto the center channel of the saw as shown.

4.Place the front table on the saw so that the mounting holes in the table line up with holes in the table supports and center chan- nel of saw.

5.Drop a flat washer into each counter- bored hole.

6.Start 1-3/4" long pan head screw through center hole and into U-clip, but do not fully tighten.

7.Start cup point set screw through leveling hole and into tee nut, but do not fully tighten.

8.Put 1" long pan head screw in each of four remaining holes and through matching holes in table supports. On end of each screw, put lockwasher then nut and tighten with screwdriver.

Tee Nut

(Install from bottom)

~

Table Mounting Holes

Top of Table

(Counterbored Holes Up

U-Clip

Set Screw

	Leveling Hole
Bolt
Washer	Pan Head Screw
	Pan Head Screw
	Washer
Lockwasher	Mounting Holes
Hex Nut

15

Image 15

Contents Inch Radial SAW Guard KIT Table of Contents Major Hazards SafetySafety Symbol and Signal Words Read and follow all safety information and instructionsKickback Hazard Guard Features Include Guard Function and FeaturesHazards Associated with Clear Por- tion of Guard Safety Instructions Personal Safety InstructionsWork Area Safety Instructions Workpiece Safety Instructions Saw Safety InstructionsBlade Safety Instructions On-Product Safety Labels Safety Assembly Identify PartsList of loose parts with model Remove Original Table Boards, and Mounting Supports Remove Sawblade and GuardPositioning Table Supports Installing Front Table Make Front Table Flat Reposition U-Clip to New Hole Location Leveling Front Table Assembly Making Front Table Flat X 13 Lock Nut Assembly Assembly Installing Guard Adapter Framing Square Must Be True Installing Blade/Squaring Crosscut TravelInstall Guard Install Fence, Rear Tables, and Table ClampsAlignment Guard Installation Steps/Align Riving Knife to BladeRequires yellow key ControlsLock before ripping Blade partially protects against Control Function Guard Tab Crosscutting Safety CrosscuttingCrosscutting Defined Keep one hand on saw handle through step Crosscut KerfsMaking Crosscuts Repetitive Crosscutting Ripping Push Sticks and Push Blocks Workpiece PositioningKickback Wrong Way Feed To reduce risk of kickbackPawls and Riving Knife Function Hold Down FunctionFollow these steps before ripping Ripping Set-up ProcedureMaking Rip Cuts Remove workpiece from table Ready push stick or push blockIn-Ripping Dado Blades, Molding Heads EdgingRipping Hints Cutting Aides Making the Handle Putting it togetherAuxiliary Fence Featherboard This Side Maintenance Clean sawdust from the slot and sliderReplacing Pawls Repair Parts #509398 & #509399Key Description Repair Parts Guard RZQHU·V Inch Radial SAW Guard KIT Pdqxdo