Craftsman 509399, 509398 owner manual Making Front Table Flat

Page 20

Assembly

16.Move the arbor shaft over the lowest point.

17.Place the handle end of the arbor wrench over this point and lower the arm until the arbor shaft is just touching the wrench. The wrench should slide back and forth with slight contact.

18.Move the arbor shaft over another point. Do not change the elevation of the arm.

19.Tighten the mounting screws and/or lev- eling screws until the handle of the arbor wrench just fits between this point and the arbor shaft. The wrench should slide back and forth with slight contact. Use a 1/8 inch hex “L” wrench to tighten the leveling screws.

20.Repeat steps 18-19 for the last two points.

Making Front Table Flat

1.Lay the edge of the rear table across the front edge of the front table. There should be no gaps between the two.

2.If you see a gap larger than 1/32 inch, tighten the center mounting screw and/or the leveling screws until the gap is gone. Use a 1/8 inch hex “L” wrench to tighten the level- ing screws.

3.Repeat steps 1-2 at the rear edge of the front table.

20

Image 20

Contents Inch Radial SAW Guard KIT Table of Contents Safety Safety Symbol and Signal WordsRead and follow all safety information and instructions Major HazardsKickback Hazard Guard Function and Features Guard Features IncludeHazards Associated with Clear Por- tion of Guard Work Area Safety Instructions Safety InstructionsPersonal Safety Instructions Saw Safety Instructions Workpiece Safety InstructionsBlade Safety Instructions On-Product Safety Labels Safety List of loose parts with model AssemblyIdentify Parts Remove Sawblade and Guard Remove Original Table Boards, and Mounting SupportsPositioning Table Supports Installing Front Table Make Front Table Flat Reposition U-Clip to New Hole Location Leveling Front Table Assembly Making Front Table Flat X 13 Lock Nut Assembly Assembly Installing Guard Adapter Installing Blade/Squaring Crosscut Travel Framing Square Must Be TrueInstall Fence, Rear Tables, and Table Clamps Install GuardGuard Installation Steps/Align Riving Knife to Blade AlignmentControls Requires yellow keyLock before ripping Blade partially protects against Control Function Guard Tab Crosscutting Defined Crosscutting SafetyCrosscutting Crosscut Kerfs Keep one hand on saw handle through stepMaking Crosscuts Repetitive Crosscutting Ripping Workpiece Positioning Push Sticks and Push BlocksKickback To reduce risk of kickback Wrong Way FeedHold Down Function Pawls and Riving Knife FunctionRipping Set-up Procedure Follow these steps before rippingRemove workpiece from table Ready push stick or push block Making Rip CutsIn-Ripping Ripping Hints Dado Blades, Molding HeadsEdging Cutting Aides Auxiliary Fence Making the HandlePutting it together Featherboard This Side Replacing Pawls MaintenanceClean sawdust from the slot and slider Key Description Repair Parts#509398 & #509399 Repair Parts Guard RZQHU·V Inch Radial SAW Guard KIT Pdqxdo