Craftsman 509399 Remove workpiece from table Ready push stick or push block, Making Rip Cuts

Page 42

Ripping

7.Remove workpiece from table.

8.Ready push stick or push block.

9.Set up table extension(s) and support their outer ends. Do not use another per- son to support workpieces because this can cause kickback and it exposes helper to potential hazards at outfeed side.

Special Notes for Bevel Set-Up

CAUTION

Bevel ripping creates unique problems of visibility and feeding. Before cut- ting, check the set-up using both in-rip and out-rip. Use the position that gives the best combination of workpiece vis- ibility and push stick clearance.

WARNING

Bevel the edge that is not against the fence.

1.When setting bevel angle, raise radial arm to allow sufficient clearance for blade and guard to not jam in table.

2.When blade is beveled manually raise clear plastic guard before lowering blade to table or kerf, otherwise it may jam in the table.

3.To set hold down, place workpiece directly under guard nose, rather than paral- lel to blade.

4.To set pawls, place workpiece directly under set of pawls closer to table. This set of pawls will keep contact with workpiece sur- face.

Making Rip Cuts

 

Follow these steps to make in-rip cuts. For

 

out-rip cuts, reverse hand functions; that is,

 

put right hand on table and use left hand to

 

support and push workpiece.

In-Ripping

1. Follow ripping set-up procedure.

 

42

Image 42
Contents Inch Radial SAW Guard KIT Table of Contents Read and follow all safety information and instructions SafetySafety Symbol and Signal Words Major HazardsKickback Hazard Guard Function and Features Guard Features IncludeHazards Associated with Clear Por- tion of Guard Safety Instructions Personal Safety InstructionsWork Area Safety Instructions Saw Safety Instructions Workpiece Safety InstructionsBlade Safety Instructions On-Product Safety Labels Safety Assembly Identify PartsList of loose parts with model Remove Sawblade and Guard Remove Original Table Boards, and Mounting SupportsPositioning Table Supports Installing Front Table Make Front Table Flat Reposition U-Clip to New Hole Location Leveling Front Table Assembly Making Front Table Flat X 13 Lock Nut Assembly Assembly Installing Guard Adapter Installing Blade/Squaring Crosscut Travel Framing Square Must Be TrueInstall Fence, Rear Tables, and Table Clamps Install GuardGuard Installation Steps/Align Riving Knife to Blade AlignmentControls Requires yellow keyLock before ripping Blade partially protects against Control Function Guard Tab Crosscutting Safety CrosscuttingCrosscutting Defined Crosscut Kerfs Keep one hand on saw handle through stepMaking Crosscuts Repetitive Crosscutting Ripping Workpiece Positioning Push Sticks and Push BlocksKickback To reduce risk of kickback Wrong Way FeedHold Down Function Pawls and Riving Knife FunctionRipping Set-up Procedure Follow these steps before rippingRemove workpiece from table Ready push stick or push block Making Rip CutsIn-Ripping Dado Blades, Molding Heads EdgingRipping Hints Cutting Aides Making the Handle Putting it togetherAuxiliary Fence Featherboard This Side Maintenance Clean sawdust from the slot and sliderReplacing Pawls Repair Parts #509398 & #509399Key Description Repair Parts Guard RZQHU·V Inch Radial SAW Guard KIT Pdqxdo