Craftsman 509398, 509399 owner manual Assembly

Page 23

Assembly

13.Using the two #8 x 3/4 pan head screws provided, attach the new handle in the same way as the old one was removed.

14.Inspect motor support cone on yoke, and cone on motor for lubrication on contacting surfaces. These surfaces should be gener- ously lubricated. If necessary lubricate with lithium white grease (not supplied).

15.Reinstall motor on motor support. Line up the index pin with the slot in the index plate. Reinstall the .505 x 7/8 x 1/16 washer and 1/2-13 locknut. Take care not to drop washer in opening of motor. Tighten nut until the bevel lock lever will lock the motor in any position when in the lock position. With the bevel lock lever in the unlocked position move the motor to any of the five index posi- tions.

If motor does not index securely, the adjust- ment is too loose.

Caution: On electronic models be sure bevel control unit is engaged with motor index plate before installing washer and lock nut.

16. Reinstall the motor support cap.

Bevel Control

Unit

Motor Index

Plate

Lubricate Cone & Motor

At Point of Contact

23

Image 23

Contents Inch Radial SAW Guard KIT Table of Contents Major Hazards SafetySafety Symbol and Signal Words Read and follow all safety information and instructionsKickback Hazard Guard Features Include Guard Function and FeaturesHazards Associated with Clear Por- tion of Guard Work Area Safety Instructions Safety InstructionsPersonal Safety Instructions Workpiece Safety Instructions Saw Safety InstructionsBlade Safety Instructions On-Product Safety Labels Safety List of loose parts with model AssemblyIdentify Parts Remove Original Table Boards, and Mounting Supports Remove Sawblade and GuardPositioning Table Supports Installing Front Table Make Front Table Flat Reposition U-Clip to New Hole Location Leveling Front Table Assembly Making Front Table Flat X 13 Lock Nut Assembly Assembly Installing Guard Adapter Framing Square Must Be True Installing Blade/Squaring Crosscut TravelInstall Guard Install Fence, Rear Tables, and Table ClampsAlignment Guard Installation Steps/Align Riving Knife to BladeRequires yellow key ControlsLock before ripping Blade partially protects against Control Function Guard Tab Crosscutting Defined Crosscutting SafetyCrosscutting Keep one hand on saw handle through step Crosscut KerfsMaking Crosscuts Repetitive Crosscutting Ripping Push Sticks and Push Blocks Workpiece PositioningKickback Wrong Way Feed To reduce risk of kickbackPawls and Riving Knife Function Hold Down FunctionFollow these steps before ripping Ripping Set-up ProcedureMaking Rip Cuts Remove workpiece from table Ready push stick or push blockIn-Ripping Ripping Hints Dado Blades, Molding HeadsEdging Cutting Aides Auxiliary Fence Making the HandlePutting it together Featherboard This Side Replacing Pawls MaintenanceClean sawdust from the slot and slider Key Description Repair Parts#509398 & #509399 Repair Parts Guard RZQHU·V Inch Radial SAW Guard KIT Pdqxdo