Craftsman 509398, 509399 owner manual X 13 Lock Nut

Page 21

Assembly

1.Pull motor/carriage to end of arm and lock the rip lock. Rotate motor to out-rip posi- tion.

2.On the rear of the motor is located the motor support cap. Remove this cap. A small screwdriver will assist you in removal of this cap. (This cap is not on all models)

3.Using a 3/4" socket, short extension and ratchet remove nut and washer from motor support. Take care not to drop washer from motor support. Take care not to drop washer during removal, it could become lodged between motor housing and motor. Slide motor off yoke and position out of way.

4.Using a #2 Phillips screwdriver, remove two pan head cross screws from motor side of handle assembly. Discard handle and 2 screws.

5.Using a #2 Phillips screwdriver, remove two pan head cross recess plastite no. 8 x 1 inch long screws from motor side of yoke assembly that hold the yoke cover in place. NOTE: Some models are clipped in place. Use a flat blade screwdriver to push the clips through from the motor side of the yoke.

6.Using a 5/16" box wrench or Phillips screwdriver remove one screw type “T” 10-32 x 1/2 from the bevel spring located in front of the yoke assembly.

1/2 x 13 Lock Nut

.505 x 7/8 x 1/16 Washer

Motor Assembly

#8 Plastite

Screws

Motor Support Cap (Not on all models)

Yoke Cover

Bevel Spring

10-32 Hex Head Screw or 10-32 Pan Head Screw

21

Image 21

Contents Inch Radial SAW Guard KIT Table of Contents Safety Symbol and Signal Words SafetyRead and follow all safety information and instructions Major HazardsKickback Hazard Guard Features Include Guard Function and FeaturesHazards Associated with Clear Por- tion of Guard Safety Instructions Personal Safety InstructionsWork Area Safety Instructions Workpiece Safety Instructions Saw Safety InstructionsBlade Safety Instructions On-Product Safety Labels Safety Assembly Identify PartsList of loose parts with model Remove Original Table Boards, and Mounting Supports Remove Sawblade and GuardPositioning Table Supports Installing Front Table Make Front Table Flat Reposition U-Clip to New Hole Location Leveling Front Table Assembly Making Front Table Flat X 13 Lock Nut Assembly Assembly Installing Guard Adapter Framing Square Must Be True Installing Blade/Squaring Crosscut TravelInstall Guard Install Fence, Rear Tables, and Table ClampsAlignment Guard Installation Steps/Align Riving Knife to BladeRequires yellow key ControlsLock before ripping Blade partially protects against Control Function Guard Tab Crosscutting Safety CrosscuttingCrosscutting Defined Keep one hand on saw handle through step Crosscut KerfsMaking Crosscuts Repetitive Crosscutting Ripping Push Sticks and Push Blocks Workpiece PositioningKickback Wrong Way Feed To reduce risk of kickbackPawls and Riving Knife Function Hold Down FunctionFollow these steps before ripping Ripping Set-up ProcedureMaking Rip Cuts Remove workpiece from table Ready push stick or push blockIn-Ripping Dado Blades, Molding Heads EdgingRipping Hints Cutting Aides Making the Handle Putting it togetherAuxiliary Fence Featherboard This Side Maintenance Clean sawdust from the slot and sliderReplacing Pawls Repair Parts #509398 & #509399Key Description Repair Parts Guard RZQHU·V Inch Radial SAW Guard KIT Pdqxdo