Craftsman 509398, 509399 owner manual In-Ripping

Page 43

Ripping

2.Insert yellow key and turn saw on.

3.Stand at infeed side and out of line of workpiece, in case of kickback. Start and finish cut from infeed side.

4.Put workpiece on table, in front of hold down, and tight against fence. To hold work- piece in position, put left hand on table, at least 8" in front of hold down, and lightly press fingers against workpiece. Support workpiece with table extension or right hand.

CAUTION

For large workpieces use a feather board in place of your hand on the table. It gives better support. (See cut- ting aides)

5.With right hand, push workpiece under hold down and into blade. Keep left hand fixed on table, applying slight pressure to keep workpiece against fence.

6.Use right hand to continue to apply feed pressure to part of workpiece close to fence. Keep hand at least 8" in front of hold down. Note: Most workpieces will automatically raise clear plastic guard as they pass from infeed to outfeed side. Unusually tall and narrow workpieces may not raise clear guard. When this happens, push guard tab to raise guard, then release tab when guard rests on top of workpiece surface.

CAUTION

Pushing guard tab means using only one hand to control workpiece. While pushing tab, use extra care to guide workpiece and to keep hand at least 8" in front of hold down.

Release tab as soon as clear guard rests on workpiece.

7.When end of workpiece gets to table, use push stick or block, instead of hand, on part of workpiece between blade and fence to push until workpiece is completely past pawls.

8.Turn saw off and wait for blade to stop spinning before touching workpiece.

Out-Ripping

Keep Hand

Back 8"

In-Ripping

Keep Hand

Back 8"

Guard

Tab

43

Image 43
Contents Inch Radial SAW Guard KIT Table of Contents Major Hazards SafetySafety Symbol and Signal Words Read and follow all safety information and instructionsKickback Hazard Guard Features Include Guard Function and FeaturesHazards Associated with Clear Por- tion of Guard Personal Safety Instructions Safety InstructionsWork Area Safety Instructions Workpiece Safety Instructions Saw Safety InstructionsBlade Safety Instructions On-Product Safety Labels Safety Identify Parts AssemblyList of loose parts with model Remove Original Table Boards, and Mounting Supports Remove Sawblade and GuardPositioning Table Supports Installing Front Table Make Front Table Flat Reposition U-Clip to New Hole Location Leveling Front Table Assembly Making Front Table Flat X 13 Lock Nut Assembly Assembly Installing Guard Adapter Framing Square Must Be True Installing Blade/Squaring Crosscut TravelInstall Guard Install Fence, Rear Tables, and Table ClampsAlignment Guard Installation Steps/Align Riving Knife to BladeRequires yellow key ControlsLock before ripping Blade partially protects against Control Function Guard Tab Crosscutting Crosscutting SafetyCrosscutting Defined Keep one hand on saw handle through step Crosscut KerfsMaking Crosscuts Repetitive Crosscutting Ripping Push Sticks and Push Blocks Workpiece PositioningKickback Wrong Way Feed To reduce risk of kickbackPawls and Riving Knife Function Hold Down FunctionFollow these steps before ripping Ripping Set-up ProcedureMaking Rip Cuts Remove workpiece from table Ready push stick or push blockIn-Ripping Edging Dado Blades, Molding HeadsRipping Hints Cutting Aides Putting it together Making the HandleAuxiliary Fence Featherboard This Side Clean sawdust from the slot and slider MaintenanceReplacing Pawls #509398 & #509399 Repair PartsKey Description Repair Parts Guard RZQHU·V Inch Radial SAW Guard KIT Pdqxdo