Craftsman 509399, 509398 owner manual Assembly

Page 22

Assembly

7. The following items can now be removed from the front of the yoke as an assembly:

a. Shaft support

 

 

b. Shaft washer

 

 

c. Washer .505 x 7/8 x 1/16

 

 

d. Bevel lock lever

 

 

e. Square nut 1/2 x 13

 

 

f. Bevel spring wedge

 

 

g. Bevel lock knob

 

 

h. Screw, pan head plastite no. 8 x 3/8"

 

b

long

 

 

c

8. Remove the bevel spring wedge from

a

d

e

this assembly by rotating shaft support coun-

 

 

f

terclockwise until it comes out of the square

 

 

nut located between the bevel lock lever and

 

h

the bevel spring wedge. Do not remove any

 

 

 

other items. Remove square nut then

 

g

remove the bevel spring wedge from the

 

bevel lock lever.

 

 

9.Replace the bevel lock lever, with new one supplied with kit. Reinsert bevel wedge in new bevel lock lever. Reinsert square nut between bevel lock lever and bevel lock wedge. Reinsert the shaft support and rotate clockwise until end of shaft is flush with the rear of the bevel lock wedge.

NOTE: Bevel lock lever must be replaced to prevent interference with guard assembly.

10.Reinstall the shaft support assembly into the yoke.

11.Reinstall the bevel spring using the screw previously removed. Make sure the slot in the bevel spring is in the groove of the index pin before tightening.

12.Reinstall the yoke cover using the plas- tite screws previously removed or by clipping back in place.

22

Image 22
Contents Inch Radial SAW Guard KIT Table of Contents Read and follow all safety information and instructions SafetySafety Symbol and Signal Words Major HazardsKickback Hazard Guard Function and Features Guard Features IncludeHazards Associated with Clear Por- tion of Guard Personal Safety Instructions Safety InstructionsWork Area Safety Instructions Saw Safety Instructions Workpiece Safety InstructionsBlade Safety Instructions On-Product Safety Labels Safety Identify Parts AssemblyList of loose parts with model Remove Sawblade and Guard Remove Original Table Boards, and Mounting SupportsPositioning Table Supports Installing Front Table Make Front Table Flat Reposition U-Clip to New Hole Location Leveling Front Table Assembly Making Front Table Flat X 13 Lock Nut Assembly Assembly Installing Guard Adapter Installing Blade/Squaring Crosscut Travel Framing Square Must Be TrueInstall Fence, Rear Tables, and Table Clamps Install GuardGuard Installation Steps/Align Riving Knife to Blade AlignmentControls Requires yellow keyLock before ripping Blade partially protects against Control Function Guard Tab Crosscutting Crosscutting SafetyCrosscutting Defined Crosscut Kerfs Keep one hand on saw handle through stepMaking Crosscuts Repetitive Crosscutting Ripping Workpiece Positioning Push Sticks and Push BlocksKickback To reduce risk of kickback Wrong Way FeedHold Down Function Pawls and Riving Knife FunctionRipping Set-up Procedure Follow these steps before rippingRemove workpiece from table Ready push stick or push block Making Rip CutsIn-Ripping Edging Dado Blades, Molding HeadsRipping Hints Cutting Aides Putting it together Making the HandleAuxiliary Fence Featherboard This Side Clean sawdust from the slot and slider MaintenanceReplacing Pawls #509398 & #509399 Repair PartsKey Description Repair Parts Guard RZQHU·V Inch Radial SAW Guard KIT Pdqxdo