Craftsman 509399, 509398 owner manual Leveling Front Table

Page 18

Assembly

7.Stand the front table on one edge. Put a mounting screw with a washer through each of the mounting holes. Then put a rubber grommet on the bottom of each mounting screw.

8.Place the front table on the saw so that the mounting screws line up with the U-clips. The front table should extend about one inch beyond the trim caps.

9.Start the mounting screws into the U- clips using a Phillips screwdriver. Tighten the screws until the heads are just touching the table. Make sure that the table is not squeez- ing the rubber grommets.

10.Start the leveling screws into the level- ing holes using a 1/8 inch hex “L” wrench. Tighten the screws until they are flush with the table.

11.From the underside of the table attach the table rails to the table board using the two holes nearest the end of each rail.

Rubber

Grommet

Mounting

Holes

	Mounting
Mounting	Hole
Holes

Front Table on Front Edge

Leveling Front Table

NOTE: The goal of this adjustment is to make the front work table flat and parallel to the radial arm. In order to do this, you will choose four points on the table. When these four points are level, the entire table should be level.

1.Loosen the three leveling screws and be sure that the five mounting screws are snug but not overtightened.

2.Raise the radial arm until the bottom of the motor is about 2-1/2 inches above the front table.

18

Image 18

Contents Inch Radial SAW Guard KIT Table of Contents Read and follow all safety information and instructions SafetySafety Symbol and Signal Words Major HazardsKickback Hazard Guard Function and Features Guard Features IncludeHazards Associated with Clear Por- tion of Guard Safety Instructions Personal Safety InstructionsWork Area Safety Instructions Saw Safety Instructions Workpiece Safety InstructionsBlade Safety Instructions On-Product Safety Labels Safety Assembly Identify PartsList of loose parts with model Remove Sawblade and Guard Remove Original Table Boards, and Mounting SupportsPositioning Table Supports Installing Front Table Make Front Table Flat Reposition U-Clip to New Hole Location Leveling Front Table Assembly Making Front Table Flat X 13 Lock Nut Assembly Assembly Installing Guard Adapter Installing Blade/Squaring Crosscut Travel Framing Square Must Be TrueInstall Fence, Rear Tables, and Table Clamps Install GuardGuard Installation Steps/Align Riving Knife to Blade AlignmentControls Requires yellow keyLock before ripping Blade partially protects against Control Function Guard Tab Crosscutting Safety CrosscuttingCrosscutting Defined Crosscut Kerfs Keep one hand on saw handle through stepMaking Crosscuts Repetitive Crosscutting Ripping Workpiece Positioning Push Sticks and Push BlocksKickback To reduce risk of kickback Wrong Way FeedHold Down Function Pawls and Riving Knife FunctionRipping Set-up Procedure Follow these steps before rippingRemove workpiece from table Ready push stick or push block Making Rip CutsIn-Ripping Dado Blades, Molding Heads EdgingRipping Hints Cutting Aides Making the Handle Putting it togetherAuxiliary Fence Featherboard This Side Maintenance Clean sawdust from the slot and sliderReplacing Pawls Repair Parts #509398 & #509399Key Description Repair Parts Guard RZQHU·V Inch Radial SAW Guard KIT Pdqxdo