Craftsman 509398, 509399 owner manual Assembly

Page 19

Assembly

3.Unlock the bevel lock to release the motor. Hold onto the motor as you do this.

CAUTION: The motor is heavy and can swing down quickly. You can be cut or injured if the arbor shaft hits you. Hold the motor when you unlock the bevel lock.

4.Turn the motor until the arbor shaft is pointing straight down toward the table.

5.Lock the bevel lock to hold the motor in this position.

6.Draw two lines on the front table, over the table rails.

7.Unlock the rip lock and pull the motor out to the end of the arm.

8.Unlock the miter lock and swing the arm to the right until the arbor shaft is over the right line at the front of the table.

9.Mark the point on the line under the cen- ter of the arbor shaft.

10.Move the arm and motor until the arbor shaft is over the right line at the rear of the front table.

11.Mark the point on the line under the cen- ter of the arbor shaft.

12.Repeat steps 7-11 on the left side.

13.Label the points A, B, C and D.

14.Move the arbor shaft over these points again, and measure the distance between the table and the bottom of the arbor shaft at each. Do not change the elevation of the arm as you move from point to point.

15.Determine which point has the largest distance between the table and the arbor shaft. This is the lowest point.

19

Image 19
Contents Inch Radial SAW Guard KIT Table of Contents Major Hazards SafetySafety Symbol and Signal Words Read and follow all safety information and instructionsKickback Hazard Guard Features Include Guard Function and FeaturesHazards Associated with Clear Por- tion of Guard Personal Safety Instructions Safety InstructionsWork Area Safety Instructions Workpiece Safety Instructions Saw Safety InstructionsBlade Safety Instructions On-Product Safety Labels Safety Identify Parts AssemblyList of loose parts with model Remove Original Table Boards, and Mounting Supports Remove Sawblade and GuardPositioning Table Supports Installing Front Table Make Front Table Flat Reposition U-Clip to New Hole Location Leveling Front Table Assembly Making Front Table Flat X 13 Lock Nut Assembly Assembly Installing Guard Adapter Framing Square Must Be True Installing Blade/Squaring Crosscut TravelInstall Guard Install Fence, Rear Tables, and Table ClampsAlignment Guard Installation Steps/Align Riving Knife to BladeRequires yellow key ControlsLock before ripping Blade partially protects against Control Function Guard Tab Crosscutting Crosscutting SafetyCrosscutting Defined Keep one hand on saw handle through step Crosscut KerfsMaking Crosscuts Repetitive Crosscutting Ripping Push Sticks and Push Blocks Workpiece PositioningKickback Wrong Way Feed To reduce risk of kickbackPawls and Riving Knife Function Hold Down FunctionFollow these steps before ripping Ripping Set-up ProcedureMaking Rip Cuts Remove workpiece from table Ready push stick or push blockIn-Ripping Edging Dado Blades, Molding HeadsRipping Hints Cutting Aides Putting it together Making the HandleAuxiliary Fence Featherboard This Side Clean sawdust from the slot and slider MaintenanceReplacing Pawls #509398 & #509399 Repair PartsKey Description Repair Parts Guard RZQHU·V Inch Radial SAW Guard KIT Pdqxdo