Stow cs403020 Stow CS4030 SAW Basic Engine Information, Accelerator system, Oil in crankcase

STOW CS4030 SAW — BASIC ENGINE INFORMATION

13	6	16
8
			12
		18	11
9
		15	2

10

3

714

	4	1	17
5
Figure 7. Basic Engine Components

Basic Engine Components

The following refer to basic engine components and their functions that an operator may need to reference . The manufacturer's engine manual provides further instructions and details of operation and servicing.The engine shown in Figure 7 is a Deutz F2L2011 engine.

1.	Fuel Filter – Removes dirt and water from the engine fuel.
2.	Governor Lever – This lever restricts engine speed (high
	idle and low idle) through a speed control device linked to
	the accelerator system.
3.	Oil Dip Stick – Remove to check amount and condition of
	oil in crankcase.
4.	Oil Filter – Spin-on type, filters oil for contaminants.

5.Oil Drain Plug – Remove plug to drain crankcase oil.

6.Oil Filler Port – Remove to add fresh crankcase oil.

7.CrankshaftV-Pulley – Check fan V-belt between V-Pulley and fan to determine proper belt tension.

8.Cooling Fan – Driven by the V-belt, the cooling fan cools the engine by cooling engine oil that circulates through the engine block and cylinder head.

9.V-belt Tension Adjustment – This bolt provides means to adjust the V-belt tension at the alternator bracket.

10.V-belt (Fan belt) – Driven by the engine crank during operation, drives the fan as well as the alternator.

11.Oil Fill Cap – Remove to add engine oil.

12.Lifting Eye – The lifting eye is provided if the removal/ installation of the engine becomes necessary.

13.Alternator – Located inside the fan assembly. Provides current to the electrical system and charges the battery. Driven by means of a crankshaft/V-belt pulley system.

14.Starter – Starts engine when ignition key is rotated to the "START" position.

15.Flywheel – Main power is taken off from the flywheel end.

16. Air Intake Port – Provides air from the air cleaner to the turbocharger unit.

17. Throttle Cable – Provides direct control of engine throttle lever from throttle control located on the console control panel.

18. Air Cleaner Assembly – Provides clean filtered air to the air intake port.

PAGE 22 — STOW CS4030 SAW • OPERATION MANUAL — REV. #0 (12/13/07)