Stow cs403026, cs 403016, cs403020, cs403030 operation manual Stow CS4030 SAW Troubleshooting

STOW CS4030 SAW — TROUBLESHOOTING

	TABLE 11. TROUBLESHOOTING (ENGINE)
SYMPTOM		POSSIBLE CAUSE		SOLUTION
		Emergency Stop Button pushed in?		Pull out E-Stop Button.
Will not start, no power with key "ON".		Battery disconnected or discharged?		Check cable connections, charge
				or replace battery.
		Ignition switch/wiring defective?		Replace ignition switch. Check
				wiring.
		Fuel not available in fuel tank (tank		Fill with correct type of fuel.
		empy)?
		Fuel filter/lines clogged?		Replace fuel filter or fuel lines.
Will not start. No fuel present.
		Fuel tank cap breather hole clogged?		Clean or replace fuel tank cap.
		Air in fuel line?		Bleed fuel line.
		Injection valve clogged or defective?		Clean or replace.
		Wrong fuel type?		Flush fuel system, and replace
				with correct type of fuel.
Difficult to start, "fuel is available and
		Contaminated fuel system? (Water, dirt)		Flush fuel system.
compression is normal".
		Air cleaner dirty?		Replace air cleaner.
		Suction/exhaust valve stuck or protruded?		Re-seat valves.
		Piston ring and/or cylinder worn?		Replace piston r ings and/or
Difficult to start, "fuel is	available and			piston.
compression is low".
		Cylinder head not tightened properly?		Torque cylinder head bolts
		Head gasket damaged?		Replace head	gaskets.
	Certain operations referred to in this
	troubleshooting section
NOTE	suchasre-seatingvalvesorreplacing		NOTE	For	further engine
	piston rings may require			troubleshooting, see your

special tools and must be performed	engine owner's manual
by trained and competent
personnel.

PAGE 56 — STOW CS4030 SAW • OPERATION MANUAL — REV. #0 (12/13/07)