STOW CS4030 SAW — OPERATION
Wheel Drive System
The STOW CS4030 saw features a
A
Figure 31. F-N-R Control
Refer to Figure 31.
■To increase the forward speed, slowly move the control handle FORWARD.
■To decrease the forward speed, pull the control handle
BACKWARD.
■When the control handle is in the Neutral position the saw will have neither a forward nor reverse motion.
■As the control handle is passed backward through the neutral position the saw will start to move in REVERSE. Reverse speed is also controlled by the position of the control handle.
STARTING AND STOPPINGTHE ENGINE
WARNING
DO NOT leave the saw unattended while the engine is running. NEVER start, park, or leave the saw unattended on a slope.
CAUTION
Allow the engine to warm up before increasing engine speed.
DO NOT stop the engine abruptly when hot. Reduce the throttle to idle and allow the engine to run one or two minutes before turning the ignition switch off. This allows the engine to cool down preventing damage to the Turbo charger.
Starting the Engine
1.Move the speed control handle to the NEUTRAL position.
2.Set the throttle to IDLE.
3.Make sure the Emergency Stop Button is in the OUT position.
4.Ensure that water lines are attached and water is flowing to the saw blade.
5.Turn the Ignition Switch to the ON position. (Figure 32.)
Figure 32. ON/OFF Switch
6.Wait for the Glow Plug Indicator Light to go out.
7.Turn Ignition Switch to the START position; RELEASE switch after engine starts.
PAGE 36 — STOW CS4030 SAW • OPERATION MANUAL — REV. #0 (12/13/07)