Graco Inc ti13461a, 311365G, ti13460a, ti13459a, ti13450a Displacement Pump Replacement for 695/795

Page 34

Displacement Pump Replacement for 695/795

Displacement Pump Replacement for 695/795

See pump manual 310643 or 310894 for pump repair instructions.

See manual 311362, 311363, or 311364 for applicable sprayer part number references.

Removal

1. Flush pump.

Relieve pressure; page 9.

2.Remove screw (31) and slide pump rod shield (108) forward.

Push up retaining ring (43) and push pump pin out.

44

ti7168a

43

4.Remove suction tube (76), hose (94) and any washers and o-rings.

5.Loosen pump jam nut (56). Unscrew pump.

ti7170a

31

108

94

ti7167a

3.Cycle pump in JOG mode until pump pin

(44)is in position to be removed. Turn

power switch OFF and unplug power cord.

5676

34

311365G

Image 34

Contents Korean patent10-0579681 Important Safety InstructionsMark Table of Contents Models Vac Model Type Lo-Boy Hi-Boy 240 Grounding Instructions GroundingFire and Explosion Hazard Skin Injection HazardPressurized Aluminum Parts Hazard Equipment Misuse HazardElectric Shock Hazard Moving Parts HazardComponent Identification and Function Pressure Relief Procedure General Repair InformationGrounding What to Check What to do Type of Problem Mechanical/Fluid FlowTroubleshooting Type of Problem What to Check HOW to Check ElectricalSprayer does not run at all Check transducer or transducer Step 100k ohm Reconnect thermal device connector to control Sprayer Will Not Shut Off YESSprayer Will Not Run See following page for stepsPressure Control Board InstallationRemoval 100 120 Vac North American Japan/Taiwan Vac Motor Control Board Vac Filter Board 240 VacVac U.K. Motor Control Board Vac U.K. Filter Board Vac U.K Pressure Adjust Potentiometer Pressure Control Transducer Install control box 61 and control panel 68 with four screws Drive and Bearing Housing Replacement DisassemblyAssembly158 108 Installation Motor ReplacementRemoval 158 90a 612 906 Displacement Pump Replacement for 695/795 Ti7169a Displacement Pump Replacement 1095/1595/Mark Open pump door Tighten latch and rotate latch lock into locked position Wiring Diagram ON/OFF Japan/Taiwan Japan/Taiwan Models Graco Standard Warranty For Graco Canada Customers