Drive and Bearing Housing Replacement
Drive and Bearing Housing Replacement
CAUTION
Do not drop gear cluster (89) when removing drive housing (90). Gear cluster may stay engaged in motor front end bell or drive housing.
DisassemblyAssembly
Relieve pressure; page 9.
1.Remove screw (31), two nuts (24), pail hanger (55) and pump rod cover (108).
2.Remove pump (91); see Displacement Pump Replacement, page 34 (695/795) page 36 (1095/1595/Mark V).
3.Remove two screws (158) and shroud (72).
4.Remove four screws (31) and front cover (51).
5.Remove four screws (14) and washers (12) to remove bearing housing (83) and connecting rod (85).
6.Remove five screws (6) and pull drive housing (90) off motor (84).
Make sure gear (89) and thrust washers (28, 30, 90a, 36; see page 29) are in place. Brush grease onto gear teeth.
1.Push drive housing (90) onto motor (84) and install with five screws (6). Torque to
2.Install bearing housing (83) with four screws (14) and washers (12). Torque to
3.Install front cover (51) with four screws (31).
4.Install shroud (72) with two screws (158).
5.Install pump (91); see Displacement Pump Replacement, page 34 (695/795) page 36 (1095/1595/Mark V).
6.Install pump rod cover (108) and pail hanger (55) with screw (31) and two nuts (24).
30 | 311365G |