Graco Inc ti13460a, 311365G, ti13459a, ti13450a Displacement Pump Replacement 1095/1595/Mark

Page 36

Displacement Pump Replacement 1095/1595/Mark V

Displacement Pump Replacement 1095/1595/Mark V

Removal

1.Flush pump.

2.Stop pump with piston rod in its lowest position.

Read Skin Injection Hazard; page 5.

3.Do Pressure Relief, page 9.

4.Separate drain hose from sprayer.

ti7326a

7.Ratchet open pump door.

a. Ratchet pump door forward.

ti6373a

b.Twist latch u-bolt out of pump door recess.

c. Place u-bolt on pump door outer edge.

d. If pump door is stuck, do steps e, f, and 8, otherwise go to step 9.

e. Twist latch u-bolt back from pump door outer edge.

ti6374a

5. Disconnect paint hose from pump.

ti6300a

f. Place u-bolt on pump door protrusion.

6. Raise latch lock. Push latch open.

ti6369a

ti6375a

ti6370a

36

311365G

Image 36
Contents Important Safety Instructions Korean patent10-0579681Mark Table of Contents Models Vac Model Type Lo-Boy Hi-Boy 240 Grounding Instructions GroundingFire and Explosion Hazard Skin Injection HazardEquipment Misuse Hazard Electric Shock HazardPressurized Aluminum Parts Hazard Moving Parts HazardComponent Identification and Function Pressure Relief Procedure General Repair InformationGrounding What to Check What to do Type of Problem Mechanical/Fluid FlowTroubleshooting Type of Problem What to Check HOW to Check ElectricalSprayer does not run at all Check transducer or transducer Step 100k ohm Reconnect thermal device connector to control Sprayer Will Not Shut Off YESSprayer Will Not Run See following page for stepsInstallation Pressure Control BoardRemoval 100 120 Vac North American Japan/Taiwan Vac Motor Control Board Vac Filter Board 240 VacVac U.K. Motor Control Board Vac U.K. Filter Board Vac U.K Pressure Adjust Potentiometer Pressure Control Transducer Install control box 61 and control panel 68 with four screws Drive and Bearing Housing Replacement DisassemblyAssembly158 108 Motor Replacement InstallationRemoval 158 90a 612 906 Displacement Pump Replacement for 695/795 Ti7169a Displacement Pump Replacement 1095/1595/Mark Open pump door Tighten latch and rotate latch lock into locked position Wiring Diagram ON/OFF Japan/Taiwan Japan/Taiwan Models Graco Standard Warranty For Graco Canada Customers