Graco Inc ti13450a, 311365G, ti13460a Tighten latch and rotate latch lock into locked position

Page 38

Displacement Pump Replacement 1095/1595/Mark V

4.Close pump door and rotate latch into position. Do not tighten latch.

ti7329a

ti6313a

6.Tighten latch and rotate latch lock into locked position.

ti6204a

TI6312a

7. Attach drain hose to sprayer.

5.Rotate pump to align with paint hose. Connect paint hose and hand tighten to 70 in-lb.

ti6299a

ti7330a

8. Fill pump with Graco TSL until fluid flows onto top of seal.

ti5493a

38

311365G

Image 38

Contents Mark Important Safety InstructionsKorean patent10-0579681 Table of Contents Models Vac Model Type Lo-Boy Hi-Boy 240 Grounding Instructions GroundingFire and Explosion Hazard Skin Injection HazardPressurized Aluminum Parts Hazard Equipment Misuse HazardElectric Shock Hazard Moving Parts HazardComponent Identification and Function Pressure Relief Procedure General Repair InformationGrounding What to Check What to do Type of Problem Mechanical/Fluid FlowTroubleshooting Type of Problem What to Check HOW to Check ElectricalSprayer does not run at all Check transducer or transducer Step 100k ohm Reconnect thermal device connector to control Sprayer Will Not Shut Off YESSprayer Will Not Run See following page for stepsRemoval InstallationPressure Control Board 100 120 Vac North American Japan/Taiwan Vac Motor Control Board Vac Filter Board 240 VacVac U.K. Motor Control Board Vac U.K. Filter Board Vac U.K Pressure Adjust Potentiometer Pressure Control Transducer Install control box 61 and control panel 68 with four screws Drive and Bearing Housing Replacement DisassemblyAssembly158 108 Removal Motor ReplacementInstallation 158 90a 612 906 Displacement Pump Replacement for 695/795 Ti7169a Displacement Pump Replacement 1095/1595/Mark Open pump door Tighten latch and rotate latch lock into locked position Wiring Diagram ON/OFF Japan/Taiwan Japan/Taiwan Models Graco Standard Warranty For Graco Canada Customers