ELECTRICAL TESTS
Test Resistor Stud Resistance | KEY |
|
|
Insert a conductive rod FF into the gun barrelA re/Megohmmeter |
| ||
| FF | Conductive Rod |
|
moved for the power supply test and against the metal | A | ||
contact GG in the front of the barrel See Fig9 | GG | Metal Contact | |
| 12 | Electrode |
|
8 Gun Barrel
Measure the resistance between the conductive rod
FF and the gun electrode 2 The resistance should be 23 megohms If the resistance is correct refer to theElectrical Troubleshooting Chart for other possi/
ble causes of poor performance or contact the nearest authorized service agency
If the resistance is outside the specified range remove the electrode 2 SeElectrode Replacement Meas/
ure the resistance between the conductive rod FF and the resistor in the inside diameter of resistor stud 6
The resistance should be 23 megohms If the resis/
tance is correct the electrode wire is defective and must |
|
| 8 | ||
|
| GG | |||
be replaced SeeElectrode Replacement If the resis/ |
|
| |||
|
|
| |||
tance is outside the specified range the resistor is de/ |
|
|
| ||
fective and the resistor stud 6 must be replaced See |
|
|
| ||
Resistor Stud Replacement |
|
|
|
| |
If you still have problems refer toElectricalhe |
|
|
| ||
|
|
| |||
Troubleshooting Chart for other possible causes of |
|
| FF | ||
poor performance or contact the nearest authorized |
|
| |||
2 | |||||
service agency |
| ||||
|
|
|
| ||
| Fig 9 |
|
|
| |